ADG1313YRUZ

125ns, 50ns SPST - NO/NC 200Ohm Analog Switches BREAK-BEFORE-MAKE ADG1313 16 Pins 10nA 15V 16-TSSOP (0.173, 4.40mm Width)

Manufacturer: Analog Devices Inc.
Nocochips NO: 84-ADG1313YRUZ
Package: 16-TSSOP (0.173, 4.40mm Width)
Datasheet: PDF
Stock: 324
Description: 125ns, 50ns SPST - NO/NC 200Ohm Analog Switches BREAK-BEFORE-MAKE ADG1313 16 Pins 10nA 15V 16-TSSOP (0.173, 4.40mm Width)(Kg)

Inquiry Now

Details

Tags

Parameters
Height	1.05mm
Length	5.1mm
Width	4.5mm
Radiation Hardening	No
REACH SVHC	No SVHC
RoHS Status	ROHS3 Compliant
Lead Free	Contains Lead
Factory Lead Time	1 Week
Lifecycle Status	PRODUCTION (Last Updated: 4 weeks ago)
Mounting Type	Surface Mount
Package / Case	16-TSSOP (0.173, 4.40mm Width)
Surface Mount	YES
Number of Pins	16
Operating Temperature	-40°C~105°C TA
Packaging	Tube
JESD-609 Code	e3
Pbfree Code	no
Part Status	Active
Moisture Sensitivity Level (MSL)	1 (Unlimited)
Number of Terminations	16
Termination	SMD/SMT
ECCN Code	EAR99
Resistance	200Ohm
Terminal Finish	Matte Tin (Sn)
Subcategory	Multiplexer or Switches
Max Power Dissipation	4.8mW
Technology	CMOS
Terminal Form	GULL WING
Peak Reflow Temperature (Cel)	260
Number of Functions	4
Supply Voltage	15V
Terminal Pitch	0.65mm
Time@Peak Reflow Temperature-Max (s)	30
Base Part Number	ADG1313
Output	SEPARATE OUTPUT
Pin Count	16
Operating Supply Voltage	12V
Number of Channels	4
Interface	Parallel
Max Supply Voltage	16.5V
Min Supply Voltage	5V
Test Frequency	1MHz
Nominal Supply Current	320μA
Power Dissipation	4.8mW
Max Supply Current	380μA
Throw Configuration	SP8T
Turn On Delay Time	125 ns
Voltage - Supply, Single/Dual (±)	12V ±15V
Supply Type	Dual, Single
Bandwidth	600MHz
Neg Supply Voltage-Nom (Vsup)	-15V
Turn-Off Delay Time	50 ns
Max Dual Supply Voltage	16.5V
On-State Resistance (Max)	200Ohm
Min Dual Supply Voltage	5V
Dual Supply Voltage	15V
Multiplexer/Demultiplexer Circuit	1:1
Off-state Isolation-Nom	80 dB
Current - Leakage (IS(off)) (Max)	10nA
Channel Capacitance (CS(off), CD(off))	5pF 5pF
On-state Resistance Match-Nom	5Ohm
Switch Circuit	SPST - NO/NC
Switch Time (Ton, Toff) (Max)	125ns, 50ns
Charge Injection	2pC
Channel-to-Channel Matching (ΔRon)	5 Ω
Crosstalk	-90dB @ 1MHz
Switching	BREAK-BEFORE-MAKE
Switch-on Time-Max	180ns
Switch-off Time-Max	60ns
Drain to Source Resistance	130Ohm

ADG1313YRUZ Overview

The electronic part can be shipped overseas conveniently because it is packaged in 16-TSSOP (0.173, 4.40mm Width). This high-reliability packaging method uses advanced packaging methods Tube. This analog switch is mounted in Surface Mount. Multiplexers and demultiplexers have a ratio of 1:1. Increasing operating temperature to around -40°C~105°C TA. A total of 16 terminations have been recorded. A high-quality output is provided by the electrical component's 4 channels. When the electronic component is given a voltage of 15V, it should be turned on and run. A total of 16 pins are injected into the electrical part body. Unlike digital switches, these are based on SPST - NO/NC switching circuits. Search with ADG1313 if you are looking for analog multiplexer variants. This digital multiplexer has 200Ohm internal resistance. Datasheets for functions of 16 pins are available. Multiplexer or Switches is a typical switch device. A voltage higher than 16.5V should not normally be supplied to the switches. Analogue multiplexers of the Dual, Single supply type that are cost-effective. 5V should be the lowest voltage fed to the electronic component. Put voltage above 380μA on the multiplexer to cause damage. Dual supply volatge is feasible for this multiplexer. But it should not go beyond 16.5V. For dual power supplies, a voltage of at least 5V should be attached. It is possible to use SEPARATE OUTPUT outputs on this digital multiplexer. A voltage of 12V can be used to operate the electronic component. A 600MHz-bandwidth can be used for data transfer. There is 130Ohm resistance between Drain and Source for this electronic part.