Parameters |
Supply Type |
Dual, Single |
Neg Supply Voltage-Nom (Vsup) |
-15V |
Turn-Off Delay Time |
130 ns |
Max Dual Supply Voltage |
22V |
On-State Resistance (Max) |
24Ohm |
Min Dual Supply Voltage |
13.5V |
High Level Output Current |
30mA |
Dual Supply Voltage |
15V |
Multiplexer/Demultiplexer Circuit |
1:1 |
Off-state Isolation-Nom |
68 dB |
Current - Leakage (IS(off)) (Max) |
250pA |
Channel Capacitance (CS(off), CD(off)) |
9pF 9pF |
On-state Resistance Match-Nom |
0.85Ohm |
Switch Circuit |
SPST - NO |
Switch Time (Ton, Toff) (Max) |
90ns, 60ns |
Charge Injection |
5pC |
Channel-to-Channel Matching (ΔRon) |
1.2 Ω |
Crosstalk |
-85dB @ 1MHz |
Switching |
BREAK-BEFORE-MAKE |
Drain to Source Resistance |
17Ohm |
Normal Position |
NO |
Voltage - Supply, Dual (V±) |
±15V |
Height |
1.5mm |
Length |
10mm |
Width |
4mm |
Radiation Hardening |
No |
REACH SVHC |
No SVHC |
RoHS Status |
ROHS3 Compliant |
Lead Free |
Contains Lead |
Factory Lead Time |
1 Week |
Lifecycle Status |
PRODUCTION (Last Updated: 1 month ago) |
Mounting Type |
Surface Mount |
Package / Case |
16-SOIC (0.154, 3.90mm Width) |
Surface Mount |
YES |
Number of Pins |
16 |
Operating Temperature |
-40°C~85°C TA |
Packaging |
Tube |
JESD-609 Code |
e3 |
Pbfree Code |
no |
Part Status |
Active |
Moisture Sensitivity Level (MSL) |
1 (Unlimited) |
Number of Terminations |
16 |
ECCN Code |
EAR99 |
Resistance |
24Ohm |
Terminal Finish |
Matte Tin (Sn) |
Subcategory |
Multiplexer or Switches |
Max Power Dissipation |
7.7μW |
Technology |
CMOS |
Terminal Form |
GULL WING |
Peak Reflow Temperature (Cel) |
260 |
Number of Functions |
4 |
Supply Voltage |
15V |
Terminal Pitch |
1.27mm |
Time@Peak Reflow Temperature-Max (s) |
30 |
Base Part Number |
ADG432 |
Pin Count |
16 |
Operating Supply Voltage |
12V |
Polarity |
Non-Inverting |
Number of Channels |
4 |
Interface |
Parallel |
Max Supply Voltage |
25V |
Min Supply Voltage |
5V |
Operating Supply Current |
100pA |
Power Dissipation |
3.5μW |
Max Supply Current |
100nA |
Throw Configuration |
SPST |
Turn On Delay Time |
165 ns |
ADG432BRZ Overview
The electrical component comes in 16-SOIC (0.154, 3.90mm Width) packaging, which makes it convenient to ship overseas. Advanced packaging method Tube is used to provide high reliability. Surface Mount is where this multiplexer is located. Multiplexers and demultiplexers have a ratio of 1:1. An extended operating temperature of -40°C~85°C TA degrees Celsius. In total, there are 16 terminations. Due to its 4 channels, the electrical component produces high-quality output. Turning on and running the electrical part should be easy with a 15V voltage supply. A total of 16 pins are injected into the body of the electronic part. Circuits based on SPST - NO switching are used to construct these analog switch ics. Look for analog switch ic variants by searching with ADG432. There is 24Ohm internal resistance in this digital multiplexer. To find out what the functions of 16 pins are, please refer to their datasheets. Multiplexer or Switches is a typical switch device. In a normalsituation, users should not supply the switches with voltage higher than 25V. A cost-effective Dual, Single supply type analogue multiplexer. It is recommended to use 5V as the lowest voltage for the electrical part. An operating current of 100pA would be sufficient for this switch device. If you put voltage higher than 100nA on the digital multiplexer, damage may occur. For this switch, a dual supply voltage is feasible, but it must not exceed 22VIt is recommended that you attach at least 13.5V to your dual power supply. It can operate from 12V operating voltages. There is 17Ohm Drain to Source resistance on this electronic part.
ADG432BRZ Features
4 Channels
Switch Circuit: SPST - NO
100pA Supply Current
Drain-to-Source resistance: 17Ohm
ADG432BRZ Applications
There are a lot of Analog Devices Inc. ADG432BRZ Analog Switches & Multiplexers ICs applications.
- High speed data transmission line cards
- Microprocessor Controlled Analog Systems
- 65 V DACs
- Remote wireless modules
- Precision instrumentation
- Fault Tolerant Systems
- Access Concentrators
- PDH Multiplexers
- Sample-and-hold systems
- Digital access cross connects