ADG444BRZ

110ns, 60ns SPST - NC 70Ohm Analog Switches BREAK-BEFORE-MAKE ADG444 16 Pins 500pA 15V 16-SOIC (0.154, 3.90mm Width)

Manufacturer: Analog Devices Inc.
Nocochips NO: 84-ADG444BRZ
Package: 16-SOIC (0.154, 3.90mm Width)
Datasheet: PDF
Stock: 279
Description: 110ns, 60ns SPST - NC 70Ohm Analog Switches BREAK-BEFORE-MAKE ADG444 16 Pins 500pA 15V 16-SOIC (0.154, 3.90mm Width)(Kg)

Details

Tags

Parameters
Factory Lead Time	1 Week
Lifecycle Status	PRODUCTION (Last Updated: 2 weeks ago)
Contact Plating	Tin
Mounting Type	Surface Mount
Package / Case	16-SOIC (0.154, 3.90mm Width)
Surface Mount	YES
Number of Pins	16
Operating Temperature	-40°C~85°C TA
Packaging	Tube
JESD-609 Code	e3
Pbfree Code	no
Part Status	Active
Moisture Sensitivity Level (MSL)	1 (Unlimited)
Number of Terminations	16
ECCN Code	EAR99
Resistance	70Ohm
Subcategory	Multiplexer or Switches
Max Power Dissipation	600mW
Technology	CMOS
Terminal Form	GULL WING
Peak Reflow Temperature (Cel)	260
Number of Functions	4
Supply Voltage	15V
Terminal Pitch	1.27mm
Time@Peak Reflow Temperature-Max (s)	30
Base Part Number	ADG444
Pin Count	16
Operating Supply Voltage	12V
Polarity	Non-Inverting
Number of Channels	4
Interface	Parallel
Max Supply Voltage	25V
Min Supply Voltage	10.8V
Power Dissipation	1.2mW
Max Supply Current	1μA
Throw Configuration	SPST
Turn On Delay Time	110 ns
Voltage - Supply, Single/Dual (±)	12V ±15V
Supply Type	Dual, Single
Neg Supply Voltage-Nom (Vsup)	-15V
Turn-Off Delay Time	60 ns
Max Dual Supply Voltage	22V
On-State Resistance (Max)	70Ohm
Min Dual Supply Voltage	13.5V
High Level Output Current	30mA
Dual Supply Voltage	15V
Multiplexer/Demultiplexer Circuit	1:1
Off-state Isolation-Nom	60 dB
Current - Leakage (IS(off)) (Max)	500pA
Channel Capacitance (CS(off), CD(off))	4pF 4pF
On-state Resistance Match-Nom	1Ohm
Switch Circuit	SPST - NC
Switch Time (Ton, Toff) (Max)	110ns, 60ns
Charge Injection	1pC
Crosstalk	-100dB @ 1MHz
Switching	BREAK-BEFORE-MAKE
Drain to Source Resistance	70Ohm
Normal Position	NC
Height	1.5mm
Length	10mm
Width	4mm
Radiation Hardening	No
REACH SVHC	No SVHC
RoHS Status	ROHS3 Compliant
Lead Free	Contains Lead

ADG444BRZ Overview

This electronic part is conveniently packaged in 16-SOIC (0.154, 3.90mm Width), making it easy to ship abroad. High reliability is ensured by the advanced packaging method Tube. Surface Mount is where this multiplexer is located. 1:1 is the ratio of multiplexer to demultiplexer circuits. An extended operating temperature of -40°C~85°C TA degrees Celsius. 16 terminations have been made so far. This electronic part offers high-quality output due to its 4 channels. It is safe to turn on and run the electronic component with a 15V voltage supply. An injection of 16 pins is performed into the body of the electrical component. These analog multiplexers are built based on SPST - NC switching circuits. Try searching for ADG444 variants of the analog switch ic. Internally, this switch multiplexer has a resistance of 70Ohm. The datasheets for the 16 pins explain the functions. Multiplexer or Switches is a typical switch device. A voltage higher than 25V should not normally be supplied to the switches. Analogue multiplexers of the Dual, Single supply type that are cost-effective. It is recommended that the electrical component receives a voltage of 10.8V. It may damage the digital multiplexer if the voltage is higher than 1μA. There's no problem with dual supply voltage for this switch device. However, it shouldn't exceed 22V. For dual power supplies, a voltage of at least 13.5V should be attached. There is a voltage range of 12V operating voltages for the electrical part. A Drain to Source resistance of 70Ohm is shown for this electronic part.