Parameters |
Max Power Dissipation |
17.5μW |
Technology |
CMOS |
Terminal Form |
GULL WING |
Peak Reflow Temperature (Cel) |
260 |
Number of Functions |
4 |
Supply Voltage |
5V |
Terminal Pitch |
1.27mm |
Time@Peak Reflow Temperature-Max (s) |
30 |
Base Part Number |
ADG451 |
Pin Count |
16 |
Operating Supply Voltage |
9V |
Polarity |
Non-Inverting |
Number of Channels |
4 |
Interface |
Parallel |
Max Supply Voltage |
12V |
Min Supply Voltage |
5V |
Operating Supply Current |
100pA |
Power Dissipation |
17.5μW |
Max Supply Current |
500nA |
Throw Configuration |
SPST |
Turn On Delay Time |
180 ns |
Supply Type |
Dual, Single |
Neg Supply Voltage-Nom (Vsup) |
-5V |
Turn-Off Delay Time |
140 ns |
Max Dual Supply Voltage |
15V |
On-State Resistance (Max) |
5Ohm |
Min Dual Supply Voltage |
5V |
High Level Output Current |
100mA |
Multiplexer/Demultiplexer Circuit |
1:1 |
Off-state Isolation-Nom |
65 dB |
Neg Supply Voltage-Max (Vsup) |
-20V |
Current - Leakage (IS(off)) (Max) |
500pA |
Channel Capacitance (CS(off), CD(off)) |
37pF 37pF |
On-state Resistance Match-Nom |
0.3Ohm |
Switch Circuit |
SPST - NC |
Switch Time (Ton, Toff) (Max) |
180ns, 140ns |
Charge Injection |
20pC |
Channel-to-Channel Matching (ΔRon) |
100m Ω |
Crosstalk |
-90dB @ 1MHz |
Switching |
BREAK-BEFORE-MAKE |
Switch-on Time-Max |
220ns |
Drain to Source Resistance |
8Ohm |
Normal Position |
NC |
Voltage - Supply, Dual (V±) |
±4.5V~20V |
Height |
1.75mm |
Length |
10mm |
Width |
4mm |
Radiation Hardening |
No |
REACH SVHC |
No SVHC |
RoHS Status |
ROHS3 Compliant |
Lead Free |
Contains Lead |
Factory Lead Time |
1 Week |
Lifecycle Status |
PRODUCTION (Last Updated: 2 weeks ago) |
Contact Plating |
Tin |
Mount |
Surface Mount |
Mounting Type |
Surface Mount |
Package / Case |
16-SOIC (0.154, 3.90mm Width) |
Number of Pins |
16 |
Operating Temperature |
-40°C~85°C TA |
Packaging |
Tape & Reel (TR) |
JESD-609 Code |
e3 |
Pbfree Code |
no |
Part Status |
Active |
Moisture Sensitivity Level (MSL) |
1 (Unlimited) |
Number of Terminations |
16 |
ECCN Code |
EAR99 |
Resistance |
5Ohm |
Additional Feature |
ALSO OPERATE WITH 12V SINGLE SUPPLY |
Subcategory |
Multiplexer or Switches |
ADG451BRZ-REEL7 Overview
Shipping overseas is convenient due to the electrical component's packing in 16-SOIC (0.154, 3.90mm Width). This packaging method provides high reliability because it uses advanced packaging techniques. Surface Mount is where this multiplexer is located. 1:1 is the ratio between multiplexers and demultiplexers. Operating temperature around -40°C~85°C TA extended. In total, there are 16 terminations. High-quality output is provided by the electronic component's 4 channels. A 5V voltage supply should turn on and run the electronic component. There are 16 pins injected into the electronic part body. These analog multiplexers are built based on SPST - NC switching circuits. Try searching with ADG451 if you're looking for variants. It has an internal resistance of 5Ohm. Datasheets for 16 pin functions are available upon request. The analog multiplexer shown here is a typical Multiplexer or Switches. A voltage higher than 12V should not normally be supplied to the switches. The digital multiplexer has a low cost Dual, Single supply. It is recommended to use 5V as the lowest voltage for the electrical part. The analogue multiplexer could operate on 100pA current. It may damage the digital multiplexer if the voltage is higher than 500nA. For this multiplexer, dual supply voltage is feasible, but it should not exceed 15V. If you are using dual power supplies, you should attach at least 5V. Operating voltages range from 9V. Additional features of the electronic component include: ALSO OPERATE WITH 12V SINGLE SUPPLY. It has a Drain to Source resistance of 8Ohm ohms.
ADG451BRZ-REEL7 Features
4 Channels
Switch Circuit: SPST - NC
100pA Supply Current
Additional Features: ALSO OPERATE WITH 12V SINGLE SUPPLY
Drain-to-Source resistance: 8Ohm
ADG451BRZ-REEL7 Applications
There are a lot of Analog Devices Inc. ADG451BRZ-REEL7 Analog Switches & Multiplexers ICs applications.
- USB 1.1 signal switching circuits
- Industrial
- Battery Powered Instruments
- Digital cross connects (DSX-1)
- PBX interfaces
- E1 Multiplexer
- Public switching systems
- Fiber to the Home
- SDH/SONET multiplexers
- Communications systems