ADG608TRUZ-REEL
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Lifecycle Status | PRODUCTION (Last Updated: 2 weeks ago) |
| Mounting Type | Surface Mount |
| Package / Case | 16-TSSOP (0.173, 4.40mm Width) |
| Surface Mount | YES |
| Number of Pins | 16 |
| Operating Temperature | -55°C~125°C TA |
| Packaging | Tape & Reel (TR) |
| JESD-609 Code | e3 |
| Pbfree Code | no |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 16 |
| ECCN Code | EAR99 |
| Resistance | 30Ohm |
| Terminal Finish | Matte Tin (Sn) |
| Additional Feature | OPERATION WITH SINGLE 3V/5V ALSO POSSIBLE |
| Technology | BICMOS |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Supply Voltage | 5V |
| Terminal Pitch | 0.65mm |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Base Part Number | ADG608 |
| Pin Count | 16 |
| Qualification Status | Not Qualified |
| Operating Supply Voltage | 5V |
| Number of Channels | 8 |
| Interface | Parallel |
| Number of Circuits | 1 |
| Max Supply Voltage | 6.5V |
| Operating Supply Current | 50nA |
| Power Dissipation | 1.5μW |
| Throw Configuration | DPST |
| Propagation Delay | 75 ns |
| Turn On Delay Time | 170 ns |
| Logic Function | Multiplexer |
| Number of Inputs | 8 |
| Voltage - Supply, Single/Dual (±) | 3.3V~5V ±5V |
| Supply Type | Dual, Single |
| Supply Current-Max (Isup) | 0.002mA |
| Neg Supply Voltage-Nom (Vsup) | -5V |
| Turn-Off Delay Time | 60 ns |
| Max Dual Supply Voltage | 6.5V |
| On-State Resistance (Max) | 30Ohm |
| Dual Supply Voltage | 5V |
| Multiplexer/Demultiplexer Circuit | 8:1 |
| Off-state Isolation-Nom | 85 dB |
| Current - Leakage (IS(off)) (Max) | 500pA |
| Channel Capacitance (CS(off), CD(off)) | 9pF 40pF |
| On-state Resistance Match-Nom | 2Ohm |
| Switch Time (Ton, Toff) (Max) | 75ns, 45ns |
| Charge Injection | 6pC |
| Channel-to-Channel Matching (ΔRon) | 5 Ω (Max) |
| Crosstalk | -85dB @ 100kHz |
| Length | 5mm |
| Width | 4.4mm |
| RoHS Status | ROHS3 Compliant |
| Lead Free | Contains Lead |
ADG608TRUZ-REEL Overview
Shipping overseas is convenient due to the electrical component's packing in 16-TSSOP (0.173, 4.40mm Width). This packaging method provides high reliability because it uses advanced packaging techniques. Surface Mount is where this multiplexer is located. The ratio between the number of multiplexer and demultiplexer circuits is 8:1. An extended operating temperature of -55°C~125°C TA degrees Celsius. In total, 16 terminations have occurred. A 8 channel electronic part produces high-quality output. If the voltage supply is 5V volts, the electrical component should be turned on and run. This electrical component is included in the 16 series of products. The multiplexer consists of 1 circuits. Try searching for the analog switch ic with ADG608 if you are looking for variants. Internally, this switch multiplexer has a resistance of 30Ohm. For functions related to 16 pins, please refer to the datasheets. A voltage higher than 6.5V should not normally be supplied to the switches. Analogue multiplexer with a Dual, Single supply type that is cost-effective. An operating current of 50nA would be sufficient for this switch device. For this switch device, it is feasible to have two supplies. However, the voltage should not exceed 6.5V. A voltage of 5V can be used to operate the electronic component. Operating the 8 inputs requires 8 inputs. Check out the electrical component's additional features, such as the following: OPERATION WITH SINGLE 3V/5V ALSO POSSIBLE.
ADG608TRUZ-REEL Features
8 Channels
50nA Supply Current
Additional Features: OPERATION WITH SINGLE 3V/5V ALSO POSSIBLE
ADG608TRUZ-REEL Applications
There are a lot of Analog Devices Inc. ADG608TRUZ-REEL Analog Switches & Multiplexers ICs applications.
- High-Voltage
- Data Acquisition Systems
- Mechanical reed relay replacement
- Battery-powered systems
- SONET
- DSUs
- Avionics and Military Systems
- Audio and video routing
- Multi-Line E1 Interface Cards
- PBXs
