ADG658YRU-REEL7
| Parameters | |
|---|---|
| Mounting Type | Surface Mount |
| Package / Case | 16-TSSOP (0.173, 4.40mm Width) |
| Surface Mount | YES |
| Number of Pins | 16 |
| Operating Temperature | -40°C~125°C TA |
| Packaging | Tape & Reel (TR) |
| JESD-609 Code | e0 |
| Pbfree Code | no |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 16 |
| ECCN Code | EAR99 |
| Resistance | 75Ohm |
| Max Power Dissipation | 10μW |
| Technology | CMOS |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 240 |
| Number of Functions | 1 |
| Supply Voltage | 5V |
| Terminal Pitch | 0.65mm |
| Reach Compliance Code | not_compliant |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Base Part Number | ADG658 |
| Pin Count | 16 |
| Qualification Status | Not Qualified |
| Operating Supply Voltage | 5V |
| Number of Channels | 8 |
| Interface | Parallel |
| Number of Circuits | 1 |
| Max Supply Voltage | 12V |
| Min Supply Voltage | 2V |
| Operating Supply Current | 10nA |
| Power Dissipation | 10μW |
| Throw Configuration | DPST |
| Logic Function | Multiplexer |
| Voltage - Supply, Single/Dual (±) | 2V~12V ±2V~6V |
| Supply Type | Dual, Single |
| Bandwidth | 210MHz |
| Neg Supply Voltage-Nom (Vsup) | -5V |
| Turn-Off Delay Time | 30 ns |
| Max Dual Supply Voltage | 6V |
| On-State Resistance (Max) | 75Ohm |
| Min Dual Supply Voltage | 2V |
| Multiplexer/Demultiplexer Circuit | 8:1 |
| Off-state Isolation-Nom | 90 dB |
| Current - Leakage (IS(off)) (Max) | 200pA |
| Channel Capacitance (CS(off), CD(off)) | 4pF 23pF |
| On-state Resistance Match-Nom | 1.3Ohm |
| Switch Time (Ton, Toff) (Max) | 115ns, 45ns |
| Charge Injection | 2pC |
| Channel-to-Channel Matching (ΔRon) | 1.3 Ω |
| Switching | BREAK-BEFORE-MAKE |
| Switch-off Time-Max | 55ns |
| Signal Current-Max | 0.02A |
| Length | 5mm |
| RoHS Status | Non-RoHS Compliant |
| Lead Free | Contains Lead |
ADG658YRU-REEL7 Overview
Due to its 16-TSSOP (0.173, 4.40mm Width) packaging, the electronic part is convenient for international shipping. This packaging method provides high reliability because it uses advanced packaging techniques. Surface Mount is where this multiplexer is located. Multiplexers and demultiplexers have a number of circuits 8:1. An extended operating temperature of -40°C~125°C TA degrees Celsius. Total terminations are 16. By its 8 channels, the electronic component provides high-quality output. Powered by a 5V voltage supply, the electrical part should be switched on and run. As part of the design of the 16 series, this electronic part has been incorporated into the system. This multiplexer is composed of 1 circuits. If you are looking for variants of the digital switch, trying search with ADG658. As far as internal resistance is concerned, it has 75Ohm. You can find the functions of the 16 pins in the datasheets. A voltage higher than 12V should not normally be supplied to the switches. Digital switch that provides Dual, Single power at a cost-effective price. There should be 2V voltage fed to the electrical part below 2V. In order to operate this switch device, it would need a current of 10nA. For this switch device, it is feasible to have two supplies. However, the voltage should not exceed 6V. When using dual power supplies, you should attach at least 2V. The electronic component can function from 5V. A 210MHz-bandwidth can be used for data transfer.
ADG658YRU-REEL7 Features
8 Channels
10nA Supply Current
Bandwidth: 210MHz
ADG658YRU-REEL7 Applications
There are a lot of Analog Devices Inc. ADG658YRU-REEL7 Analog Switches & Multiplexers ICs applications.
- Mechanical reed relay replacement
- Automotive applications
- ISDN NT1/TA
- Video switching
- ADCs such as AD7840/8, AD7870/1/2/4/5/6/8
- Imaging
- Cable Modem
- PBX interfaces
- Access Concentrators
- Cellular phones
