ADG702BRJ-500RL7
| Parameters | |
|---|---|
| Mounting Type | Surface Mount |
| Package / Case | SC-74A, SOT-753 |
| Surface Mount | YES |
| Number of Pins | 5 |
| Packaging | Cut Tape (CT) |
| JESD-609 Code | e0 |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 5 |
| ECCN Code | EAR99 |
| Resistance | 3Ohm |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Subcategory | Multiplexer or Switches |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 240 |
| Number of Functions | 1 |
| Supply Voltage | 3V |
| Reach Compliance Code | not_compliant |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Base Part Number | ADG702 |
| Pin Count | 5 |
| Qualification Status | Not Qualified |
| Temperature Grade | INDUSTRIAL |
| Number of Channels | 1 |
| Max Supply Voltage | 5.5V |
| Min Supply Voltage | 1.8V |
| Number of Bits | 1 |
| Throw Configuration | SPST |
| -3db Bandwidth | 200MHz |
| Off-state Isolation-Nom | 55 dB |
| Switching | BREAK-BEFORE-MAKE |
| Switch-on Time-Max | 20ns |
| Normal Position | NC |
| Length | 2.9mm |
| RoHS Status | Non-RoHS Compliant |
ADG702BRJ-500RL7 Overview
Due to its SC-74A, SOT-753 packaging, the electronic part is convenient for international shipping. This high-reliability packaging method uses advanced packaging methods Cut Tape (CT). Surface Mount is where this multiplexer is located. Total terminations are 5. This electronic part offers high-quality output due to its 1 channels. Powered by a 3V voltage supply, the electrical part should be switched on and run. This electrical component is included in the 5 series of products. Try searching with ADG702 to find analog multiplexer variants. A 3Ohm internal resistance characterizes this multiplexer. The functions of 5 pins can be found in the datasheets. Theswitch device is a typical Multiplexer or Switches. It is generally not recommended to supply a voltage higher than 5.5V to the switch device in normal circumstances. 1.8V is the lowest voltage the electrical component should receive. It is not recommended to operate the switches in an environment with a temperature higher than 85°C. It is capable of carrying out 1-bit operation.
ADG702BRJ-500RL7 Features
1 Channels
-3db Bandwidth: 200MHz
1-Bit
ADG702BRJ-500RL7 Applications
There are a lot of Analog Devices Inc. ADG702BRJ-500RL7 Analog Switches & Multiplexers ICs applications.
- DVD-R
- Precision data acquisition
- PBXs
- USB 1.1 signal switching circuits
- Fault Tolerant Systems
- Data switching
- Microprocessor Controlled Analog Systems
- Private Branch Exchange (PBX)
- Access Concentrators
- Data Acquisition Systems
