ADG702LBRTZ-REEL
| Parameters | |
|---|---|
| Mounting Type | Surface Mount |
| Package / Case | SOT-23-6 |
| Surface Mount | YES |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tape & Reel (TR) |
| JESD-609 Code | e3 |
| Pbfree Code | yes |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 6 |
| Terminal Finish | MATTE TIN |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Supply Voltage | 3V |
| Terminal Pitch | 0.95mm |
| Reach Compliance Code | unknown |
| Time@Peak Reflow Temperature-Max (s) | NOT SPECIFIED |
| Pin Count | 6 |
| JESD-30 Code | R-PDSO-G6 |
| Supply Voltage-Max (Vsup) | 5.5V |
| Number of Channels | 1 |
| Number of Circuits | 1 |
| -3db Bandwidth | 200MHz |
| On-State Resistance (Max) | 3Ohm |
| Multiplexer/Demultiplexer Circuit | 1:1 |
| Off-state Isolation-Nom | 55 dB |
| Current - Leakage (IS(off)) (Max) | 250pA |
| Channel Capacitance (CS(off), CD(off)) | 17pF 17pF |
| On-state Resistance Match-Nom | 1.5Ohm |
| Switch Circuit | SPST - NC |
| Switch Time (Ton, Toff) (Max) | 12ns, 8ns (Typ) |
| Charge Injection | 5pC |
| Switch-on Time-Max | 20ns |
| Voltage - Supply, Single (V+) | 1.8V~5V |
| Length | 2.9mm |
| RoHS Status | ROHS3 Compliant |
ADG702LBRTZ-REEL Overview
As the electronic part is packed in SOT-23-6, international shipping is convenient. A high level of reliability can be achieved through the use of an advanced packaging method Tape & Reel (TR). Multiplexers like this are mounted in the Surface Mount position. The ratio between the number of multiplexer and demultiplexer circuits is 1:1. An extended operating temperature of -40°C~85°C TA degrees Celsius. There are 6 terminations totally. Due to its 1 channels, the electrical component produces high-quality output. Powered by a 3V voltage supply, the electrical part should be switched on and run. A total of 6 pins are injected into the electrical part body. On the other hand, analog switches can be constructed using SPST - NC switching circuits. Circuits number 1 make up this analogue multiplexer. A voltage of 1.8V~5V is required to drain this analog switch from a single voltage supply.
ADG702LBRTZ-REEL Features
1 Channels
Switch Circuit: SPST - NC
-3db Bandwidth: 200MHz
ADG702LBRTZ-REEL Applications
There are a lot of Rochester Electronics, LLC ADG702LBRTZ-REEL Analog Switches & Multiplexers ICs applications.
- Precision data acquisition
- Video signal routing
- Central office
- Wireless Local Loop
- Data switching
- MP3 players
- Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads
- Channel Banks
- SONET/SDH ADM
- Sample-and-hold systems
