Parameters |
Factory Lead Time |
1 Week |
Lifecycle Status |
PRODUCTION (Last Updated: 3 weeks ago) |
Contact Plating |
Tin |
Mount |
Surface Mount |
Mounting Type |
Surface Mount |
Package / Case |
16-SOIC (0.154, 3.90mm Width) |
Number of Pins |
16 |
Operating Temperature |
-40°C~85°C TA |
Packaging |
Tube |
JESD-609 Code |
e3 |
Pbfree Code |
no |
Part Status |
Active |
Moisture Sensitivity Level (MSL) |
1 (Unlimited) |
Number of Terminations |
16 |
ECCN Code |
EAR99 |
Resistance |
4Ohm |
Additional Feature |
CAN ALSO OPERATE WITH 5 V SUPPLY |
Subcategory |
Multiplexer or Switches |
Max Power Dissipation |
520mW |
Technology |
CMOS |
Terminal Position |
DUAL |
Terminal Form |
GULL WING |
Peak Reflow Temperature (Cel) |
260 |
Number of Functions |
4 |
Supply Voltage |
3V |
Terminal Pitch |
1.27mm |
Time@Peak Reflow Temperature-Max (s) |
30 |
Base Part Number |
ADG712 |
Pin Count |
16 |
Polarity |
Non-Inverting |
Power Supplies |
3/5V |
Number of Channels |
4 |
Interface |
Parallel |
Max Supply Voltage |
5.5V |
Min Supply Voltage |
1.8V |
Operating Supply Current |
1nA |
Nominal Supply Current |
1μA |
Power Dissipation |
5μW |
Max Supply Current |
1μA |
Throw Configuration |
SPST |
Turn On Delay Time |
11 ns |
Bandwidth |
200MHz |
Turn-Off Delay Time |
6 ns |
On-State Resistance (Max) |
4Ohm |
High Level Output Current |
30mA |
Multiplexer/Demultiplexer Circuit |
1:1 |
Off-state Isolation-Nom |
58 dB |
Current - Leakage (IS(off)) (Max) |
100pA |
Channel Capacitance (CS(off), CD(off)) |
10pF 10pF |
On-state Resistance Match-Nom |
0.1Ohm |
Switch Circuit |
SPST - NO |
Switch Time (Ton, Toff) (Max) |
11ns, 6ns (Typ) |
Charge Injection |
3pC |
Crosstalk |
-90dB @ 10MHz |
Switching |
BREAK-BEFORE-MAKE |
Switch-on Time-Max |
20ns |
Switch-off Time-Max |
12ns |
Voltage - Supply, Single (V+) |
1.8V~5.5V |
Drain to Source Resistance |
2.5Ohm |
Normal Position |
NC |
Height |
1.5mm |
Length |
10mm |
Width |
4mm |
Radiation Hardening |
No |
REACH SVHC |
No SVHC |
RoHS Status |
ROHS3 Compliant |
Lead Free |
Contains Lead |
ADG712BRZ Overview
As the electronic part is packed in 16-SOIC (0.154, 3.90mm Width), international shipping is convenient. This packaging method provides high reliability because it uses advanced packaging techniques. The multiplexer is located in Surface Mount. 1:1 is the ratio between multiplexers and demultiplexers. Increasing operating temperature to around -40°C~85°C TA. There are 16 terminations totally. This electronic part offers high-quality output due to its 4 channels. It is safe to turn on and run the electronic component with a 3V voltage supply. A key feature of the 16 series is the inclusion of this electronic part as part of its design. A SPST - NO switching circuit is used for these analog switches. Try searching with ADG712 to find analog multiplexer variants. It has an internal resistance of 4Ohm. Datasheets for functions of 16 pins are available. It is a typical Multiplexer or Switches analog multiplexer. Users should never supply a voltage higher than 5.5V to a switch device. A low voltage of 1.8V should be applied to the electronic component. In order to operate this switch device, it would need a current of 1nA. Using only a single voltage supply, this analog switch requires 1.8V~5.5V voltage. The switch multiplexer may be damaged if it is exposed to voltage greater than 1μA. The data can be transferred over a wide range of bandwidths, called 200MHz bandwidths. Additional features of the electronic component include: CAN ALSO OPERATE WITH 5 V SUPPLY. There is 2.5Ohm resistance between the Drain and Source on this part.
ADG712BRZ Features
4 Channels
Switch Circuit: SPST - NO
1nA Supply Current
Bandwidth: 200MHz
Additional Features: CAN ALSO OPERATE WITH 5 V SUPPLY
Drain-to-Source resistance: 2.5Ohm
ADG712BRZ Applications
There are a lot of Analog Devices Inc. ADG712BRZ Analog Switches & Multiplexers ICs applications.
- Precision test equipment
- Industrial and process control systems
- Intelligent PBX
- Battery-powered systems
- Avionics test equipment
- Battery Powered Instruments
- High speed data transmission line cards
- DSLAMs
- SDH/SONET multiplexers
- New designs requiring multiplexer functions