ADG714BRUZ
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Lifecycle Status | PRODUCTION (Last Updated: 3 months ago) |
| Contact Plating | Tin |
| Mounting Type | Surface Mount |
| Package / Case | 24-TSSOP (0.173, 4.40mm Width) |
| Surface Mount | YES |
| Number of Pins | 24 |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tube |
| JESD-609 Code | e3 |
| Pbfree Code | no |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 24 |
| ECCN Code | EAR99 |
| Resistance | 4.5Ohm |
| Additional Feature | ALSO OPERATES WITH 2.7V TO 5.5V SINGLE SUPPLY |
| Subcategory | Multiplexer or Switches |
| Max Power Dissipation | 125μW |
| Technology | CMOS |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 8 |
| Supply Voltage | 2.5V |
| Terminal Pitch | 0.65mm |
| Time@Peak Reflow Temperature-Max (s) | 40 |
| Base Part Number | ADG714 |
| Pin Count | 24 |
| Power Supplies | 3/5/+-3V |
| Number of Channels | 8 |
| Interface | Serial |
| Max Supply Voltage | 5.5V |
| Min Supply Voltage | 2.7V |
| Nominal Supply Current | 20μA |
| Power Dissipation | 125μW |
| Max Supply Current | 20μA |
| Throw Configuration | SPST |
| Turn On Delay Time | 32 ns |
| Voltage - Supply, Single/Dual (±) | 2.7V~5.5V ±2.5V |
| Supply Type | Dual, Single |
| Bandwidth | 155MHz |
| Neg Supply Voltage-Nom (Vsup) | -2.5V |
| Turn-Off Delay Time | 15 ns |
| Max Dual Supply Voltage | 2.75V |
| On-State Resistance (Max) | 4.5Ohm |
| Min Dual Supply Voltage | 2.25V |
| High Level Output Current | 30mA |
| Dual Supply Voltage | 2.5V |
| Multiplexer/Demultiplexer Circuit | 1:1 |
| Off-state Isolation-Nom | 60 dB |
| Current - Leakage (IS(off)) (Max) | 100pA |
| Channel Capacitance (CS(off), CD(off)) | 11pF 11pF |
| On-state Resistance Match-Nom | 0.4Ohm |
| Switch Circuit | SPST - NO |
| Switch Time (Ton, Toff) (Max) | 20ns, 8ns (Typ) |
| Charge Injection | 3pC |
| Crosstalk | -90dB @ 1MHz |
| Switching | BREAK-BEFORE-MAKE |
| Drain to Source Resistance | 4.5Ohm |
| Normal Position | NC |
| Signal Current-Max | 0.1A |
| Height | 1.05mm |
| Length | 7.8mm |
| Width | 4.4mm |
| Radiation Hardening | No |
| REACH SVHC | No SVHC |
| RoHS Status | ROHS3 Compliant |
| Lead Free | Contains Lead |
ADG714BRUZ Overview
The electronic part can be shipped overseas conveniently because it is packaged in 24-TSSOP (0.173, 4.40mm Width). This high-reliability packaging method uses advanced packaging methods Tube. It is mounted in the position Surface Mount. Multiplexers and demultiplexers have a number of circuits 1:1. Around -40°C~85°C TA is the extended operating temperature. In total, 24 terminations have occurred. The electronic part delivers high-quality output through its 8 channels. With a 2.5V voltage supply, the electrical component should be turned on and run. As part of its design, the 24 series is equipped with this electronic component. Circuits based on SPST - NO switching are used to construct these analog switch ics. Try searching with ADG714 to find analog multiplexer variants. There is 4.5Ohm internal resistance in this digital multiplexer. The datasheets for the 24 pins explain the functions. Theswitch device is a typical Multiplexer or Switches. In a normalsituation, users should not supply the switches with voltage higher than 5.5V. Dual, Single supply type digital switch with a low cost. In order for the electronic part to function properly, the lowest voltage should be 2.7V. A digital multiplexer may suffer damage if voltage is applied above 20μA. For this multiplexer, dual supply voltage is feasible, but it should not exceed 2.75V. If you are using dual power supplies, you should attach at least 2.25V. It is possible to transfer data over a 155MHz-bandwidth. Additional features include: ALSO OPERATES WITH 2.7V TO 5.5V SINGLE SUPPLY. It has a Drain to Source resistance of 4.5Ohm ohms.
ADG714BRUZ Features
8 Channels
Switch Circuit: SPST - NO
Bandwidth: 155MHz
Additional Features: ALSO OPERATES WITH 2.7V TO 5.5V SINGLE SUPPLY
Drain-to-Source resistance: 4.5Ohm
ADG714BRUZ Applications
There are a lot of Analog Devices Inc. ADG714BRUZ Analog Switches & Multiplexers ICs applications.
- Audio signal routing
- DSLAMs
- Multiplexers
- Cell phones
- Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads
- Audio/video switches
- Access Concentrators
- PCMCIA cards
- Microwave transmission systems
- Communications systems
