ADG719BRTZ-REEL7

7ns, 3ns (Typ) SPDT 4Ohm DUAL Analog Switches BREAK-BEFORE-MAKE ADG719 6 Pins 250pA 3V SOT-23-6

Manufacturer: Analog Devices Inc.
Nocochips NO: 84-ADG719BRTZ-REEL7
Package: SOT-23-6
Datasheet: PDF
Stock: 812
Description: 7ns, 3ns (Typ) SPDT 4Ohm DUAL Analog Switches BREAK-BEFORE-MAKE ADG719 6 Pins 250pA 3V SOT-23-6(Kg)

Details

Tags

Parameters
Factory Lead Time	1 Week
Lifecycle Status	PRODUCTION (Last Updated: 4 weeks ago)
Contact Plating	Tin
Mount	Surface Mount
Mounting Type	Surface Mount
Package / Case	SOT-23-6
Number of Pins	6
Operating Temperature	-40°C~125°C TA
Packaging	Tape & Reel (TR)
JESD-609 Code	e3
Pbfree Code	no
Part Status	Active
Moisture Sensitivity Level (MSL)	1 (Unlimited)
Number of Terminations	6
ECCN Code	EAR99
Resistance	4Ohm
Subcategory	Multiplexer or Switches
Max Power Dissipation	282mW
Technology	CMOS
Terminal Position	DUAL
Terminal Form	GULL WING
Peak Reflow Temperature (Cel)	260
Number of Functions	1
Supply Voltage	3V
Terminal Pitch	0.95mm
Time@Peak Reflow Temperature-Max (s)	40
Base Part Number	ADG719
Pin Count	6
Number of Outputs	2
Polarity	Non-Inverting
Power Supplies	3/5V
Number of Channels	1
Interface	Parallel
Max Supply Voltage	5.5V
Min Supply Voltage	1.8V
Operating Supply Current	1nA
Nominal Supply Current	1nA
Power Dissipation	5μW
Max Supply Current	1μA
Turn On Delay Time	7 ns
Bandwidth	200MHz
Turn-Off Delay Time	3 ns
On-State Resistance (Max)	4Ohm
High Level Output Current	30mA
Multiplexer/Demultiplexer Circuit	2:1
Off-state Isolation-Nom	67 dB
Current - Leakage (IS(off)) (Max)	250pA
Channel Capacitance (CS(off), CD(off))	7pF
On-state Resistance Match-Nom	0.1Ohm
Switch Circuit	SPDT
Switch Time (Ton, Toff) (Max)	7ns, 3ns (Typ)
Crosstalk	-82dB @ 1MHz
Switching	BREAK-BEFORE-MAKE
Switch-off Time-Max	8ns
Voltage - Supply, Single (V+)	1.8V~5.5V
Max Junction Temperature (Tj)	150°C
Drain to Source Resistance	4Ohm
On-State Resistance	2.5Ohm
Height	1.45mm
Length	2.9mm
Width	1.6mm
Radiation Hardening	No
REACH SVHC	No SVHC
RoHS Status	ROHS3 Compliant
Lead Free	Contains Lead

ADG719BRTZ-REEL7 Overview

Due to its SOT-23-6 packaging, the electronic part is convenient for international shipping. High reliability is achieved by using advanced packaging method Tape & Reel (TR). Surface Mount is where this multiplexer is located. Multiplexer and demultiplexer circuits have a number 2:1. The operating temperature is extended to around -40°C~125°C TA. In total, there are 6 terminations. High-quality output is provided by the electronic component's 1 channels. In the case of a voltage supply of 3V volts, the electrical part can be powered up and run. It is part of the design of the 6 series that this electronic component is included. A SPDT switching circuit is used for these analog switches. Try searching for ADG719 variants of the analog switch ic. There is 4Ohm internal resistance in this digital multiplexer. To find out what the functions of 6 pins are, please refer to their datasheets. Multiplexer or Switches is a typical switch device. An abnormal situation would be for the switch device to be supplied with a voltage greater than 5.5V. There should be 1.8V voltage fed to the electrical part below 1.8V. The analogue multiplexer could operate on 1nA current. Using a single voltage supply, this switch device consumes 1.8V~5.5V volts. If put voltage greater than 1μA on the device, damage may be caused to the analogue multiplexer. 200MHz bandwidths enable data to be transferred. This electronic component presents a Drain to Source resistance of 4Ohm. A analog switch ics with 2 outputs is included.