ADM1086AKS-REEL7
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 6-TSSOP, SC-88, SOT-363 |
| Number of Pins | 6 |
| Operating Temperature | -40°C~85°C |
| Packaging | Cut Tape (CT) |
| JESD-609 Code | e0 |
| Pbfree Code | no |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 6 |
| ECCN Code | EAR99 |
| Type | Sequencer |
| Subcategory | Power Management Circuits |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 240 |
| Number of Functions | 1 |
| Supply Voltage | 3.3V |
| Reach Compliance Code | not_compliant |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Base Part Number | ADM1086 |
| Output | Push-Pull, Totem Pole |
| Pin Count | 6 |
| Qualification Status | Not Qualified |
| Power Supplies | 2.5/3.3V |
| Number of Channels | 1 |
| Max Supply Voltage | 3.6V |
| Min Supply Voltage | 2.25V |
| Adjustable Threshold | YES |
| Reset | Active High |
| Number of Voltages Monitored | 1 |
| Reset Timeout | Adjustable/Selectable |
| Min Reset Threshold Voltage | 560mV |
| Max Reset Threshold Voltage | 640mV |
| Length | 2mm |
| RoHS Status | Non-RoHS Compliant |
ADM1086AKS-REEL7 Overview
There are 6 terminals connected to this power management, which makes it easy to mount. There is a Cut Tape (CT)-packaging method applied to IC management. In this IC power you will find 1 functions for you to refer to. A series of 1 channels can be found on this supervisor. Please find attached 6-TSSOP, SC-88, SOT-363 functions for your reference in this IC power. There are a lot of similarities between this IC management and other Sequencer products. IC management is specified that the package peak reflow temperature should be 240. In a 3.3V supply voltage, the power management conducts. Power management conducts at a voltage of 1. Surface Mount is the one that mounts power management. The power management system can be categorized as a Power Management Circuits chip. In total, the power management has 6 pins in it. There are 6 pins on the supervisor. Normally, the supply voltage (Vsup) for this PMIC should not be lower than 2.25V. Voltage (Vsup) shouldn't exceed 3.6V volts in this PMIC. The mounting type of the supervisors is Surface MountThis range of temperature should be set for the supervisors: -40°C~85°C. While this power management is operating, it will output Push-Pull, Totem Pole as the output voltage. For similar manage ics search of the manufacturer, you can always refer to ADM1086, the base PMIC number. The power management must be powered by 2.5/3.3V volts to function properly.
ADM1086AKS-REEL7 Features
Sequencer type
Minimum supply voltage of 2.25V
ADM1086AKS-REEL7 Applications
There are a lot of Analog Devices Inc. ADM1086AKS-REEL7 Voltage Supervisors applications.
- DC stabilized power supply module
- Radar
- Radio
- FPGA design
- Satellite navigation
- Telecommunications equipment
- Magnetic resonance imaging
- Detection of phase imbalance
- Power distribution systems of CCU
- Kitchen appliances
