banner_page

ALD4213PCL

130ns, 130ns SPST - NO/NC 135Ohm Analog Switches 100pA 16-DIP (0.300, 7.62mm)


  • Manufacturer: Advanced Linear Devices Inc.
  • Nocochips NO: 16-ALD4213PCL
  • Package: 16-DIP (0.300, 7.62mm)
  • Datasheet: PDF
  • Stock: 835
  • Description: 130ns, 130ns SPST - NO/NC 135Ohm Analog Switches 100pA 16-DIP (0.300, 7.62mm)(Kg)

Details

Tags

Parameters
Factory Lead Time 1 Week
Mounting Type Through Hole
Package / Case 16-DIP (0.300, 7.62mm)
Number of Pins 16
Supplier Device Package 16-PDIP
Operating Temperature -40°C~85°C TA
Packaging Tube
Published 2016
Part Status Active
Moisture Sensitivity Level (MSL) 1 (Unlimited)
Resistance 135Ohm
Max Operating Temperature 85°C
Min Operating Temperature -40°C
Max Power Dissipation 600mW
Number of Circuits 4
Max Supply Voltage 12V
Min Supply Voltage 3V
Nominal Supply Current 10nA
Max Supply Current 1μA
Turn On Delay Time 300 ns
Voltage - Supply, Single/Dual (±) 3V~12V ±1.5V~6V
Turn-Off Delay Time 1.5 μs
Max Dual Supply Voltage 6V
On-State Resistance (Max) 135Ohm
Multiplexer/Demultiplexer Circuit 1:1
Current - Leakage (IS(off)) (Max) 100pA
Channel Capacitance (CS(off), CD(off)) 3pF 3pF
Switch Circuit SPST - NO/NC
Switch Time (Ton, Toff) (Max) 130ns, 130ns
Charge Injection 0.2pC
Channel-to-Channel Matching (ΔRon) 2.7Ohm
Crosstalk -90dB @ 100kHz
RoHS Status ROHS3 Compliant

ALD4213PCL Overview


Packed in 16-DIP (0.300, 7.62mm), the electronic component is convenient for shipping overseas. This high-reliability packaging method uses advanced packaging methods Tube. The multiplexer is located in Through Hole. 1:1 is the number of circuits in the multiplexer and demultiplexer. Operational temperature extended around -40°C~85°C TA. These analog multiplexers are built based on SPST - NO/NC switching circuits. 4 circuits are used in this analogue multiplexer. Internally, this switch multiplexer has a resistance of 135Ohm. The datasheets for the 16 pins explain the functions. Multiplexers should not be powered above 12V in normal situations. The lowest voltage fed to the electronic component should be 3V. The analogue multiplexer may be damaged if voltage is greater than 1μA. If put voltage greater than 6V on the multiplexer, damage may be caused to the device. The switches should not operate in an environment where the temperature is higher than 85°C. Suppliers offer 16-PDIP packages.

ALD4213PCL Features


Switch Circuit: SPST - NO/NC

ALD4213PCL Applications


There are a lot of Advanced Linear Devices Inc. ALD4213PCL Analog Switches & Multiplexers ICs applications.

  • T1/E1 Terminals
  • PBX interfaces
  • Low-Voltage
  • Fault Tolerant Systems
  • Relay replacements
  • Communication systems
  • FTTH
  • Cell phones
  • Automotive applications
  • Fiber In The Loop (FITL)

Write a review

Note: HTML is not translated!
    Bad           Good