AN8015SH-E1
| Parameters | |
|---|---|
| Mounting Type | Surface Mount |
| Package / Case | 10-FSOP (0.169, 4.30mm Width) |
| Number of Pins | 10 |
| Supplier Device Package | 10-SSOP |
| Operating Temperature | -30°C~85°C TA |
| Packaging | Tape & Reel (TR) |
| Published | 2007 |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -30°C |
| Base Part Number | AN8015SH |
| Function | Step-Up, Step-Down |
| Number of Outputs | 1 |
| Output Voltage | 35V |
| Output Type | Transistor Driver |
| Output Configuration | Positive or Negative |
| Output Current | 100mA |
| Voltage - Supply (Vcc/Vdd) | 3.6V~34V |
| Output Power | 154mW |
| Control Features | Frequency Control |
| Topology | Buck, Boost |
| Frequency - Switching | 2kHz~500kHz |
| Synchronous Rectifier | No |
| Max Duty Cycle | 90 % |
| Duty Cycle (Max) | 90% |
| Clock Sync | No |
| Output Phases | 1 |
| Number of Output Phases | 1 |
| RoHS Status | Non-RoHS Compliant |
| Lead Free | Contains Lead |
AN8015SH-E1 Overview
With a 10-FSOP (0.169, 4.30mm Width) package, the switching controller is suitable for a wide range of applications. 1 outputs are supported by the dc motor controller. An enclosure of Tape & Reel (TR) is used to package the PMIC. Transistor Driver dc switching's outputs (s) are supported. The supply and operating voltage of the dc control are 3.6V~34V. Workable in an dc switcher where -30°C~85°C TA is the -30°C~85°C TArm. With this switching controller, you can switch at 2kHz~500kHz. Surface Mount makes it suitable for general dc dc regulator. DCDC regulator is controlled efficiently by Frequency Control. Other relevant dc to dc converter ics can be found by searching "AN8015SH". There are a total of 10 pins on switching converter. According to the test statistics, DC regulator outputs 35V voltage. A starting point for a project is to note down the dc dc regulator's usual output current, which is 100mA. It is set to 90 % duty cycle to ensure voltage regulator dc to dc reliability during power-ups and power-downs. At -30°C and above, dc regulator should be kept. A temperature of 85°C more than 85°C degrees Celsius should be maintained in the undc regulator. This part's supplier dc dc controller package would be 10-SSOP. This controller contains 1 phases.
AN8015SH-E1 Features
Transistor Driver Outputs
Switching Frequency: 2kHz~500kHz
Frequency Control
Max Duty Cycle: 90 %
AN8015SH-E1 Applications
There are a lot of Panasonic Electronic Components AN8015SH-E1 DC to DC converter applications.
- Industrial controllers
- Hydraulic presses
- Printing equipment
- Electrical distribution systems
- Computed tomography (CT)
- Wide-range voltage regulation circuits
- Driver circuits
- Mobile phones
- Planers
- ATMs
