banner_page

AOZ1361DI-01

P-Channel 0.65mm PMIC 10 Pin 12V 10-WDFN Exposed Pad


  • Manufacturer: Alpha & Omega Semiconductor Inc.
  • Nocochips NO: 62-AOZ1361DI-01
  • Package: 10-WDFN Exposed Pad
  • Datasheet: -
  • Stock: 683
  • Description: P-Channel 0.65mm PMIC 10 Pin 12V 10-WDFN Exposed Pad (Kg)

Details

Tags

Parameters
Factory Lead Time 1 Week
Mount Surface Mount
Mounting Type Surface Mount
Package / Case 10-WDFN Exposed Pad
Number of Pins 10
Operating Temperature -40°C~85°C TA
Packaging Tape & Reel (TR)
Published 2006
Feature Auto Restart, Slew Rate Controlled, Status Flag
Part Status Active
Moisture Sensitivity Level (MSL) 1 (Unlimited)
Number of Terminations 10
ECCN Code EAR99
Terminal Position DUAL
Terminal Form NO LEAD
Number of Functions 1
Supply Voltage 12V
Terminal Pitch 0.65mm
Pin Count 10
Number of Outputs 1
Qualification Status Not Qualified
Output Type P-Channel
Supply Voltage-Max (Vsup) 28V
Supply Voltage-Min (Vsup) 4.5V
Interface On/Off
Output Configuration High Side
Voltage - Supply (Vcc/Vdd) Not Required
Input Type Non-Inverting
Switch Type General Purpose
Ratio - Input:Output 1:1
Voltage - Load 4.5V~28V
Fault Protection Current Limiting (Adjustable), Over Temperature, UVLO
Output Peak Current Limit-Nom 2.7A
Rds On (Typ) 22m Ω
Built-in Protections THERMAL
Output Current Flow Direction SOURCE
Height Seated (Max) 0.8mm
Length 4mm
Width 4mm
RoHS Status ROHS3 Compliant

AOZ1361DI-01 Overview


The package is in the form of a Tape & Reel (TR).It is included with the 10-WDFN Exposed Pad package as well.The lighting driver is mounted in the Surface Mount position.The switch type is General Purpose.It is recommended that the temperature be set to -40°C~85°C TA for reliable performance.In this LED driver, there are no outputs available.A supply voltage of Not Required is required for it to operate.There is a maximum output voltage of P-Channel volts.This LED driving board is equipped with Auto Restart, Slew Rate Controlled, Status Flag features in order for it to be useful.A total of 10 terminations can be found in it.It is necessary to use the 10 pins in order to operate the LED driver.It consists of 1 functions.High efficiency is possible at 12V supply voltage.Surface Mount is mounted in the way of this lighting driver.10 pins are connected to it in total.The LED driver is configured with a maximum supply voltage of 28V (Vsup).For normal operation, the supply voltage (Vsup) must be kept above 4.5V.

AOZ1361DI-01 Features


Supplied from 12V

AOZ1361DI-01 Applications


There are a lot of Alpha & Omega Semiconductor Inc. AOZ1361DI-01 Power Switches ICs applications.

  • Storage (HDDs, SSDs)
  • Low Voltage I/O System Power
  • PDAs
  • PC Cards
  • USB Power Distribution
  • PC Card Hot Swap
  • HDD, SSD
  • Portable GPS Device
  • Notebook PC
  • Wearable Devices

Write a review

Note: HTML is not translated!
    Bad           Good