AP2281-1WG-7
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | SOT-23-6 |
| Number of Pins | 6 |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tape & Reel (TR) |
| Published | 2009 |
| JESD-609 Code | e3 |
| Feature | Load Discharge, Slew Rate Controlled |
| Pbfree Code | yes |
| Part Status | Discontinued |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 6 |
| Resistance | 210mOhm |
| Terminal Finish | Matte Tin (Sn) |
| Max Power Dissipation | 720mW |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Supply Voltage | 5V |
| Terminal Pitch | 0.95mm |
| Current Rating | 2A |
| Time@Peak Reflow Temperature-Max (s) | 40 |
| Base Part Number | AP2281 |
| Pin Count | 6 |
| Number of Outputs | 1 |
| Output Type | P-Channel |
| Max Output Current | 2A |
| Interface | On/Off |
| Output Configuration | High Side |
| Power Dissipation | 720mW |
| Output Current | 0A |
| Voltage - Supply (Vcc/Vdd) | Not Required |
| Input Type | Non-Inverting |
| Switch Type | General Purpose |
| Ratio - Input:Output | 1:1 |
| Voltage - Load | 1.5V~6V |
| Telecom IC Type | TELECOM CIRCUIT |
| Rds On (Typ) | 80m Ω |
| Length | 3mm |
| Radiation Hardening | No |
| REACH SVHC | No SVHC |
| RoHS Status | ROHS3 Compliant |
| Lead Free | Lead Free |
AP2281-1WG-7 Overview
A Tape & Reel (TR) is used to package it.It is included with the SOT-23-6 package as well.The lighting driver is mounted in the Surface Mount position.The switch type of this switch is General Purpose.To ensure reliable operation, set the temperature to -40°C~85°C TA.As a default, the output is set to 1.The LED driving board is powered by a voltage of Not Required.A maximum output voltage of P-Channel volts can be obtained with this LED driver.It is equipped with Load Discharge, Slew Rate Controlled features.I believe it belongs to the AP2281 family.It contains 6 terminations.The 6 pins are used to operate the LED driver.The LED driving board has a total of 1 functions.The maximum output current must drop to 2A to meet the operation criteria.Using a voltage of 5V allows for high efficiency.The lighting driver is mounted in the way of Surface Mount.In total, it has 6 pins.Currently, the LED driving board has a resistance of 210mOhm ohms.As a result, the output current is set to 0A.
AP2281-1WG-7 Features
Supplied from 5V
Resistance of 210mOhm
AP2281-1WG-7 Applications
There are a lot of Diodes Incorporated AP2281-1WG-7 Power Switches ICs applications.
- HDD and SSD
- Wearable Devices
- Notebook PC
- Handheld Devices
- Solid State Drivers
- Wireless/Networking Cards
- PC Cards
- USB Ports/Hubs
- Portable Devices
- USB Power Distribution
