AP2301AM8-13
| Parameters | |
|---|---|
| Mounting Type | Surface Mount |
| Package / Case | 8-TSSOP, 8-MSOP (0.118, 3.00mm Width) |
| Surface Mount | YES |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tape & Reel (TR) |
| JESD-609 Code | e3 |
| Feature | Load Discharge, Slew Rate Controlled, Status Flag |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 8 |
| ECCN Code | EAR99 |
| Terminal Finish | Matte Tin (Sn) |
| Subcategory | Peripheral Drivers |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | NOT SPECIFIED |
| Supply Voltage | 5V |
| Terminal Pitch | 0.635mm |
| Time@Peak Reflow Temperature-Max (s) | NOT SPECIFIED |
| JESD-30 Code | R-PDSO-G8 |
| Number of Outputs | 1 |
| Qualification Status | Not Qualified |
| Output Type | P-Channel |
| Power Supplies | 5V |
| Interface | On/Off |
| Current - Output (Max) | 2A |
| Output Configuration | High Side |
| Voltage - Supply (Vcc/Vdd) | Not Required |
| Input Type | Non-Inverting |
| Switch Type | USB Switch |
| Ratio - Input:Output | 1:1 |
| Voltage - Load | 2.7V~5.5V |
| Driver Number of Bits | 1 |
| Fault Protection | Current Limiting (Fixed), Over Temperature, Reverse Current, UVLO |
| Rds On (Typ) | 70m Ω |
| RoHS Status | ROHS3 Compliant |
AP2301AM8-13 Overview
It is packaged in the form of a Tape & Reel (TR).It is included in the package 8-TSSOP, 8-MSOP (0.118, 3.00mm Width).This LED driving board is mounted using the mounting type Surface Mount.USB Switch is the switch type it owns.It is best to set the temperature to -40°C~85°C TA to ensure reliable operation.The LED driver is equipped with 1 outputs.It uses a supply voltage of Not Required to operate.A maximum output voltage of P-Channel volts can be achieved by this LED driver.Load Discharge, Slew Rate Controlled, Status Flag features are available on the lighting driver.A total of 8 terminations have been recorded.This lighting driver is capable of delivering a maximum output of 2A volts.A supply voltage of 5V leads to high efficiency.Self-contained LED driver with Peripheral Drivers capacity in an econtainer.A 5V power supply is used by the part.
AP2301AM8-13 Features
Supplied from 5V
AP2301AM8-13 Applications
There are a lot of Diodes Incorporated AP2301AM8-13 Power Switches ICs applications.
- Portable GPS Device
- Hard Disk Drives
- Wireless Headsets
- PC Card Hot Swap
- Set-Top Boxes
- Hot-Swap Systems
- USB Ports/Hubs
- Low Voltage I/O System Power
- Wireless/Networking Cards
- Notebook and Tablet Computers
