AP2411AM8-13
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mounting Type | Surface Mount |
| Package / Case | 8-TSSOP, 8-MSOP (0.118, 3.00mm Width) |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tape & Reel (TR) |
| Published | 2006 |
| JESD-609 Code | e3 |
| Feature | Load Discharge, Slew Rate Controlled, Status Flag |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| ECCN Code | EAR99 |
| Terminal Finish | Matte Tin (Sn) |
| Peak Reflow Temperature (Cel) | NOT SPECIFIED |
| Time@Peak Reflow Temperature-Max (s) | NOT SPECIFIED |
| Number of Outputs | 1 |
| Output Type | P-Channel |
| Max Output Current | 2A |
| Interface | On/Off |
| Output Configuration | High Side |
| Voltage - Supply (Vcc/Vdd) | Not Required |
| Input Type | Non-Inverting |
| Switch Type | USB Switch |
| Ratio - Input:Output | 1:1 |
| Voltage - Load | 2.7V~5.5V |
| Fault Protection | Current Limiting (Fixed), Over Temperature, Reverse Current, UVLO |
| Rds On (Typ) | 70m Ω |
| RoHS Status | ROHS3 Compliant |
AP2411AM8-13 Overview
It is packaged in the form of a Tape & Reel (TR).There is a package for it in the 8-TSSOP, 8-MSOP (0.118, 3.00mm Width) package.Surface Mount is the mounting type of the LED driver.A USB Switch switch type is owned by it.It is best to set the temperature to -40°C~85°C TA to ensure reliable operation.The LED driver has a total of 1 outputs.A voltage of Not Required is used to power it.A maximum output voltage of P-Channel volts can be obtained with this LED driver.In terms of features, the LED driving board has Load Discharge, Slew Rate Controlled, Status Flag.This results in the maximum output current dropping to 2A to meet the operation criteria.
AP2411AM8-13 Features
AP2411AM8-13 Applications
There are a lot of Diodes Incorporated AP2411AM8-13 Power Switches ICs applications.
- USB Ports/Hubs
- Smartphone and PDA
- Storage (HDDs, SSDs)
- Storage Drives
- Portable GPS Device
- HDD, SSD
- Hot Swap
- Solid-State Drives
- Portable GPS
- USB Power Distribution
