ATF1500A-7JC
| Parameters | |
|---|---|
| Peak Reflow Temperature (Cel) | 225 |
| Supply Voltage | 5V |
| Terminal Pitch | 1.27mm |
| Frequency | 166.7MHz |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Pin Count | 44 |
| Qualification Status | Not Qualified |
| Operating Supply Voltage | 5V |
| Power Supplies | 5V |
| Temperature Grade | COMMERCIAL |
| Max Supply Voltage | 5.25V |
| Min Supply Voltage | 4.75V |
| Number of I/O | 32 |
| Memory Type | FLASH |
| Propagation Delay | 7.5 ns |
| Output Function | MACROCELL |
| Number of Macro Cells | 32 |
| JTAG BST | NO |
| In-System Programmable | NO |
| Height Seated (Max) | 4.572mm |
| Length | 16.586mm |
| Width | 16.586mm |
| RoHS Status | Non-RoHS Compliant |
| Lead Free | Contains Lead |
| Mount | Surface Mount |
| Package / Case | J |
| Number of Pins | 44 |
| JESD-609 Code | e0 |
| Moisture Sensitivity Level (MSL) | 2 |
| Number of Terminations | 44 |
| Terminal Finish | Tin/Lead (Sn/Pb) |
| Max Operating Temperature | 70°C |
| Min Operating Temperature | 0°C |
| Additional Feature | NO |
| HTS Code | 8542.39.00.01 |
| Subcategory | Programmable Logic Devices |
| Technology | CMOS |
| Terminal Position | QUAD |
ATF1500A-7JC Overview
32 macrocells are present in the mobile phone network, which offer radio coverage from a high-power cell tower, antenna, or mast.There is a J package containing it.There are 32 I/Os on the board.44terminations have been programmed into the device.As the terminal position of this electrical part is [0], it serves as an important access point for passengers and freight.The device is powered by a voltage of 5V volts.It is a part of family [0].44pins are programmed on the chip.It is also possible to find NOwhen using this device.It is recommended that the supply voltage be kept at 5Vto maximize efficiency.It is recommended that data be stored in [0].In this case, Surface Mountis used to mount the electronic component.A total of 44pins are provided on this board.It operates at a maximum supply voltage of 5.25V volts.A minimum supply voltage of 4.75V is required for this device to operate.It runs on a voltage of 5Vvolts.This can be achieved at a frequency of 166.7MHz.In order to operate, the temperature should be higher than 0°C.A temperature lower than 70°Cis recommended for operation.
ATF1500A-7JC Features
J package
32 I/Os
44 pin count
44 pins
5V power supplies
ATF1500A-7JC Applications
There are a lot of Atmel (Microchip Technology) ATF1500A-7JC CPLDs applications.
- I/O PORTS (MCU MODULE)
- Code converters
- Auxiliary Power Supply Isolated and Non-isolated
- State machine control
- Voltage level translation
- Timing control
- Power Meter SMPS
- White goods (Washing, Cold, Aircon ,...)
- Synchronous or asynchronous mode
- USB Bus
