ATF1508ASL-25QC100
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Package / Case | PQFP |
| Number of Pins | 100 |
| JESD-609 Code | e0 |
| Moisture Sensitivity Level (MSL) | 3 |
| Number of Terminations | 100 |
| Terminal Finish | Tin/Lead (Sn/Pb) |
| Max Operating Temperature | 70°C |
| Min Operating Temperature | 0°C |
| HTS Code | 8542.39.00.01 |
| Subcategory | Programmable Logic Devices |
| Terminal Position | QUAD |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 225 |
| Supply Voltage | 5V |
| Terminal Pitch | 0.65mm |
| Reach Compliance Code | unknown |
| Time@Peak Reflow Temperature-Max (s) | NOT SPECIFIED |
| Pin Count | 100 |
| Qualification Status | Not Qualified |
| Supply Voltage-Max (Vsup) | 5.25V |
| Power Supplies | 3.3/55V |
| Temperature Grade | COMMERCIAL |
| Supply Voltage-Min (Vsup) | 4.75V |
| Number of I/O | 80 |
| Clock Frequency | 33.3MHz |
| Propagation Delay | 25 ns |
| Programmable Logic Type | EE PLD |
| Output Function | MACROCELL |
| Number of Macro Cells | 128 |
| JTAG BST | YES |
| In-System Programmable | YES |
| Height Seated (Max) | 3.4mm |
| Length | 20mm |
| Width | 14mm |
| RoHS Status | Non-RoHS Compliant |
| Lead Free | Contains Lead |
ATF1508ASL-25QC100 Overview
There are 128 macro cells in the network, which are high-power cell sites that provide radio coverage (tower, antenna, or mast) for a mobile phone network.In the PQFPpackage, you will find it.The device is programmed with 80 I/O ports.It is programmed to terminate devices at [0].This electrical part has a terminal position of QUADand is connected to the ground.Power is provided by a supply voltage of 5V volts.It belongs to the family [0].Chips are programmed with 100 pins.In this case, it is mounted by Surface Mount.The 100pins are designed into the board.A total of 3.3/55V power supplies are needed to run it.In this case, the maximum supply voltage (Vsup) is 5.25V.It is recommended that the operating temperature be higher than 0°C.It is recommended that the operating temperature be below 70°C.A supply voltage (Vsup) of greater than 4.75V should be used.It should not exceed 33.3MHzin its clock frequency.It is possible to classify programmable logic as EE PLD.
ATF1508ASL-25QC100 Features
PQFP package
80 I/Os
100 pin count
100 pins
3.3/55V power supplies
ATF1508ASL-25QC100 Applications
There are a lot of Atmel (Microchip Technology) ATF1508ASL-25QC100 CPLDs applications.
- State machine design
- Multiple DIP Switch Replacement
- LED Lighting systems
- High speed graphics processing
- Dedicated input registers
- Software-driven hardware configuration
- Field programmable gate
- I/O PORTS (MCU MODULE)
- Network Interface Card (NIC) and Host Bus Adapter (HBA)
- ToR/Aggregation/Core Switch and Router
