banner_page

ATF750C-10SC

5V 1.27mm PMIC 24 Pin 90MHz 5V S


  • Manufacturer: Atmel (Microchip Technology)
  • Nocochips NO: 69-ATF750C-10SC
  • Package: S
  • Datasheet: -
  • Stock: 923
  • Description: 5V 1.27mm PMIC 24 Pin 90MHz 5V S (Kg)

Details

Tags

Parameters
Number of Gates 750
Output Function MACROCELL
Number of Macro Cells 10
JTAG BST NO
Number of Dedicated Inputs 11
In-System Programmable NO
Height Seated (Max) 2.65mm
Length 15.4mm
Width 7.5mm
RoHS Status Non-RoHS Compliant
Lead Free Contains Lead
Mount Surface Mount
Package / Case S
Number of Pins 24
JESD-609 Code e0
Moisture Sensitivity Level (MSL) 2
Number of Terminations 24
Max Operating Temperature 70°C
Min Operating Temperature 0°C
Additional Feature NO
HTS Code 8542.39.00.01
Terminal Position DUAL
Terminal Form GULL WING
Peak Reflow Temperature (Cel) 240
Supply Voltage 5V
Terminal Pitch 1.27mm
Frequency 90MHz
Time@Peak Reflow Temperature-Max (s) 30
Pin Count 24
Qualification Status Not Qualified
Operating Supply Voltage 5V
Power Supplies 5V
Temperature Grade COMMERCIAL
Max Supply Voltage 5.25V
Min Supply Voltage 4.75V
Number of I/O 10
Memory Type EEPROM
Propagation Delay 10 ns
Frequency (Max) 90MHz
Programmable Logic Type EE PLD

ATF750C-10SC Overview


A mobile phone network consists of 10macro cells, which are radio coverage cells served by a high-power cell site (tower, antenna or mast).It is embedded in the S package.It is equipped with 10I/O ports.The termination of a device is set to [0].Its terminal position is DUAL.The power supply voltage is 5V.It is equipped with 24 pin count.If you use this device, you will also find [0].A digital circuit is built using 750gates.If high efficiency is to be achieved, the supply voltage should be maintained at [0].Data is stored using [0].The electronic part is mounted by Surface Mount.There are 24pins on it.In this case, the maximum supply voltage is 5.25V.The minimal supply voltage is 4.75V.It operates from 5V power supplies.There is 90MHz frequency that can be achieved.It is recommended that the operating temperature be higher than 0°C.It is recommended to keep the operating temperature below 70°C.The status of input signals is determined by 11dedicated inputs.Maximum frequency should be less than 90MHz.In programmable logic, a type of logic can be categorized as EE PLD.

ATF750C-10SC Features


S package
10 I/Os
24 pin count
24 pins
5V power supplies

ATF750C-10SC Applications


There are a lot of Atmel (Microchip Technology) ATF750C-10SC CPLDs applications.

  • DDC INTERFACE
  • Software-Driven Hardware Configuration
  • Cross-Matrix Switch
  • Bootloaders for FPGAs
  • Power Meter SMPS
  • STANDARD SERIAL INTERFACE UART
  • SUPERVISORY FUNCTION (LVD AND WATCHDOG)
  • Page register
  • I/O PORTS (MCU MODULE)
  • ANALOG-TO-DIGITAL CONVERTOR (ADC)

Write a review

Note: HTML is not translated!
    Bad           Good