AZ7500BP-E1
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mount | Through Hole |
| Mounting Type | Through Hole |
| Package / Case | 16-DIP (0.300, 7.62mm) |
| Number of Pins | 16 |
| Supplier Device Package | 16-DIP |
| Weight | 1.627801g |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tube |
| Published | 2003 |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Function | Step-Down |
| Number of Outputs | 1 |
| Output Voltage | 36V |
| Output Type | Transistor Driver |
| Operating Supply Voltage | 15V |
| Operating Supply Current | 6mA |
| Output Configuration | Positive |
| Output Current | 200mA |
| Voltage - Supply (Vcc/Vdd) | 7V~36V |
| Control Features | Enable |
| Topology | Buck |
| Frequency - Switching | 1kHz~200kHz |
| Synchronous Rectifier | No |
| Max Duty Cycle | 45 % |
| Duty Cycle (Max) | 45% |
| Clock Sync | No |
| Output Phases | 1 |
| Number of Output Phases | 1 |
| Radiation Hardening | No |
| RoHS Status | ROHS3 Compliant |
AZ7500BP-E1 Overview
It comes in a 16-DIP (0.300, 7.62mm) package, so switching controller can be used for most applications. 1 outputs are supported by the dc motor controller. The pmic is packaged in Tube solid enclosure. It is capable of handling Transistor Driver dc switching's outputs (s). Voltages 7V~36V are the dc control's supply voltage and operating voltage, respectively. Qualified to work in a -40°C~85°C TA dc switcher. It can switch at 1kHz~200kHz. dc dc regulators can be carried out with Through Hole. Featured in the dcdc regulator is Enable which allows efficient switching control. 16 pins are on switching converter. According to the test statistics, DC regulator outputs 36V voltage. If you are starting a new project, you should note the dc dc regulator's typical output current is 200mA. The duty cycle of the voltage regulator dc to dc can be set to 45 % on power-up or power-down to ensure reliability. This Through Hole makes DC switcher suitable for most prototypes and applications. When running the voltage regulator dc to dc in a circuit, users should apply 15V to ensure safety and reliability. At least -40°C°C is recommended. DC regulator should run at a temperature 85°C higher than 85°C. Its supplier dc dc controller package is 16-DIP. It runs on a 6mA supply current. The phase of this controller is 1.
AZ7500BP-E1 Features
Transistor Driver Outputs
Switching Frequency: 1kHz~200kHz
Enable
Max Duty Cycle: 45 %
AZ7500BP-E1 Applications
There are a lot of Diodes Incorporated AZ7500BP-E1 DC to DC converter applications.
- Fire elevators
- Remotely powered electric motors
- Television equipment
- Household control circuits
- Flaw detection equipment
- Scientific testing
- Direct power supply system
- Laboratories
- Wind power
- Grinders
