AZ7500FMTR-G1
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 16-SOIC (0.154, 3.90mm Width) |
| Number of Pins | 16 |
| Supplier Device Package | 16-SOIC |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tape & Reel (TR) |
| Published | 2003 |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Function | Step-Down |
| Number of Outputs | 1 |
| Output Voltage | 5V |
| Output Type | Transistor Driver |
| Operating Supply Voltage | 15V |
| Output Configuration | Positive |
| Voltage - Supply (Vcc/Vdd) | 7V~36V |
| Control Features | Enable |
| Topology | Buck |
| Frequency - Switching | 1kHz~200kHz |
| Synchronous Rectifier | No |
| Max Duty Cycle | 45 % |
| Duty Cycle (Max) | 45% |
| Clock Sync | No |
| Output Phases | 1 |
| Number of Output Phases | 1 |
| Radiation Hardening | No |
| RoHS Status | RoHS Compliant |
AZ7500FMTR-G1 Overview
Capsuled in the 16-SOIC (0.154, 3.90mm Width) package, the switching controller suits most application needs. It is sufficient to generate 1 outputs with this dc motor controller. An enclosure of Tape & Reel (TR) is used to package the PMIC. The program can handle Transistor Driver dc switching's outputs (s). dc control's supply and operating voltages are 7V~36V. Work well in dc switchers with a -40°C~85°C TA. The switching controller can be switched at 1kHz~200kHz. The Surface Mount makes it ideal for general dc dc regulator. In order to control switching efficiently, the dcdc regulator features Enable. There are a total of 16 pins on switching converter. The test statistics indicate that DC regulator outputs a voltage of 5V. As a result of this, the maximum duty cycle of the voltage regulator dc to dc must remain 45 % during power-up and power-down. In most applications and prototypes, DC switcher's Surface Mount makes it suitable. It is suggested that users apply 15V to the voltage regulator dc to dc in order to run it safely and reliably in a circuit. You should keep dc regulator at -40°C degrees or higher. DC regulator should run at a temperature 85°C higher than 85°C. The supplier dc dc controller package for this part would be 16-SOIC. Phases of this controller are 1.
AZ7500FMTR-G1 Features
Transistor Driver Outputs
Switching Frequency: 1kHz~200kHz
Enable
Max Duty Cycle: 45 %
AZ7500FMTR-G1 Applications
There are a lot of Diodes Incorporated AZ7500FMTR-G1 DC to DC converter applications.
- Power supplies of electronic gadgets
- Surge protection circuits
- Elevator lighting
- SMT equipment
- Flaw detection equipment
- Fire elevators
- Grinders
- Servo drive system
- Remotely powered electric motors
- Constant current circuits
