BD63823EFV-E2
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 28-VSSOP (0.173, 4.40mm Width) Exposed Pad |
| Operating Temperature | -25°C~150°C TJ |
| Packaging | Cut Tape (CT) |
| Published | 2012 |
| Part Status | Not For New Designs |
| Moisture Sensitivity Level (MSL) | 3 (168 Hours) |
| Number of Terminations | 28 |
| ECCN Code | EAR99 |
| Applications | Printer |
| HTS Code | 8542.39.00.01 |
| Subcategory | Motion Control Electronics |
| Technology | DMOS |
| Voltage - Supply | 19V~28V |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | NOT SPECIFIED |
| Supply Voltage | 24V |
| Terminal Pitch | 0.65mm |
| Time@Peak Reflow Temperature-Max (s) | NOT SPECIFIED |
| JESD-30 Code | R-PDSO-G28 |
| Function | Driver - Fully Integrated, Control and Power Stage |
| Qualification Status | Not Qualified |
| Power Supplies | 24V |
| Supply Voltage-Min (Vsup) | 19V |
| Interface | Parallel |
| Analog IC - Other Type | BRUSH DC MOTOR CONTROLLER |
| Output Configuration | Half Bridge (4) |
| Current - Output | 2A |
| Logic Function | AND |
| Supply Current-Max (Isup) | 5mA |
| Voltage - Load | 19V~28V |
| Motor Type - AC, DC | Brushed DC |
| Step Resolution | 1, 1/2 |
| Height Seated (Max) | 1mm |
| Length | 9.7mm |
| Width | 4.4mm |
| RoHS Status | ROHS3 Compliant |
BD63823EFV-E2 Overview
The design contains a Cut Tape (CT)package.The part is packaged in a 28-VSSOP (0.173, 4.40mm Width) Exposed Pad case.A mounting position of Surface Mountis recommended for the part.As a result, it is appropriate for the component connected to Printer.A device with a voltage range of 19V~28V volts is available.This device operates at a temperature range of -25°C~150°C TJ.There is a motor type Brushed DCassociated with this motor type.There are 28 terminations available in the part.Voltage can be applied at a rate of 19V~28V volts to the load.Drivers controllers is very important to keep in mind that this amplifier should be operated at 24V.Surface Mountis its recommended mounting method.The output current should remain at 2A.There is an analog integrated circuit BRUSH DC MOTOR CONTROLLERpresent in the device.The Motion Control Electronicsseries contains it.
BD63823EFV-E2 Features
Applications : Printer
Load voltage across the chip 19V~28V
BD63823EFV-E2 Applications
There are a lot of ROHM Semiconductor BD63823EFV-E2 motor drivers applications.
- Building technology
- Alternative to HID lights
- Street lights
- High brightness LED lighting
- RGB and monochromatic LED drivers for signage and traffic signals
- drivers for outdoor application
- High power LED street light
- Daytime running lights (DRLs)
- General lighting
- Architectural lighting
