BD6395FP-E2
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 25-SOP (0.213, 5.40mm Width) + 2 Heat Tabs |
| Number of Pins | 25 |
| Operating Temperature | -25°C~150°C TJ |
| Packaging | Tape & Reel (TR) |
| Published | 2012 |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 25 |
| Termination | SMD/SMT |
| ECCN Code | EAR99 |
| Applications | General Purpose |
| Subcategory | Motion Control Electronics |
| Technology | DMOS |
| Voltage - Supply | 16V~28V |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Supply Voltage | 24V |
| Terminal Pitch | 0.8mm |
| Base Part Number | BD639* |
| Function | Driver - Fully Integrated, Control and Power Stage |
| Number of Outputs | 4 |
| Supply Voltage-Max (Vsup) | 28V |
| Supply Voltage-Min (Vsup) | 16V |
| Interface | Parallel |
| Analog IC - Other Type | STEPPER MOTOR CONTROLLER |
| Nominal Supply Current | 3mA |
| Output Configuration | Half Bridge (4) |
| Current - Output | 1.2A |
| Logic Function | AND |
| Supply Current-Max (Isup) | 10mA |
| Voltage - Load | 16V~28V |
| Motor Type - Stepper | Bipolar |
| Step Resolution | 1, 1/2, 1/4 |
| Height | 1.9mm |
| Length | 13.6mm |
| Width | 5.4mm |
| Radiation Hardening | No |
| REACH SVHC | No SVHC |
| RoHS Status | ROHS3 Compliant |
| Lead Free | Lead Free |
BD6395FP-E2 Overview
This package was designed with Tape & Reel (TR)in mind.25-SOP (0.213, 5.40mm Width) + 2 Heat Tabscases are included with the part.Drivers controllers is recommended that the part be mounted by Surface Mount.I believe it is suitable for the component connected to General Purpose.This device is capable of supplying voltages up to 16V~28V volts.With regard to operating temperature, it ranges -25°C~150°C TJ. There are 25 terminations available in the part.In this case, the voltage can be applied to the load at the rate of 16V~28V.Drivers controllers is important to remember that this amplifier should be run at 24V.Its recommended mounting way is Surface Mount.Maintain a current of 1.2A for the part output.The device employs the STEPPER MOTOR CONTROLLER analog IC.The BD639*part number allows us to locate it.A device with 25pins is available.The Motion Control Electronicsseries contains it.Currently, there are 4 outputs available.
BD6395FP-E2 Features
Applications : General Purpose
Load voltage across the chip 16V~28V
base on BD639* number
designed with 4 outputs
BD6395FP-E2 Applications
There are a lot of ROHM Semiconductor BD6395FP-E2 motor drivers applications.
- Tail lights
- Fog lamps
- Home lighting systems
- Scanning equipment
- Commercial office
- Landscape lighting
- CHMSL (center high-mount stop lamps)
- Automotive instrumentation
- A cross between entertainment
- PDAs
