BD82000FVJ-LBE2
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mounting Type | Surface Mount |
| Package / Case | 8-TSSOP, 8-MSOP (0.118, 3.00mm Width) |
| Surface Mount | YES |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Cut Tape (CT) |
| Published | 2014 |
| Feature | Slew Rate Controlled, Status Flag |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 8 |
| ECCN Code | EAR99 |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | NOT SPECIFIED |
| Number of Functions | 1 |
| Supply Voltage | 5V |
| Terminal Pitch | 0.65mm |
| Time@Peak Reflow Temperature-Max (s) | NOT SPECIFIED |
| JESD-30 Code | S-PDSO-G8 |
| Number of Outputs | 1 |
| Output Type | N-Channel |
| Max Output Current | 1A |
| Supply Voltage-Max (Vsup) | 5.5V |
| Supply Voltage-Min (Vsup) | 2.7V |
| Interface | On/Off |
| Output Configuration | High Side |
| Voltage - Supply (Vcc/Vdd) | Not Required |
| Input Type | Non-Inverting |
| Switch Type | USB Switch |
| Ratio - Input:Output | 1:1 |
| Voltage - Load | 2.7V~5.5V |
| Fault Protection | Current Limiting (Fixed), Over Temperature, UVLO |
| Turn On Time | 20000 µs |
| Output Peak Current Limit-Nom | 1A |
| Rds On (Typ) | 70m Ω |
| Turn Off Time | 40 µs |
| Built-in Protections | OVER CURRENT; THERMAL; UNDER VOLTAGE |
| Output Current Flow Direction | SINK |
| Length | 3mm |
| Width | 3mm |
| RoHS Status | ROHS3 Compliant |
BD82000FVJ-LBE2 Overview
A Cut Tape (CT) is used to package it.There is a 8-TSSOP, 8-MSOP (0.118, 3.00mm Width) package that includes it.Surface Mount is the mounting type of the LED driver.There is a USB Switch switch type associated with it.Ensure reliable operation by setting the temperature to -40°C~85°C TA.The lighting driver is equipped with 1 outputs that can be used.To operate, it needs a supply voltage of Not Required.There is a maximum output voltage of N-Channel volts.Currently, the LED driving board is equipped with Slew Rate Controlled, Status Flag features.It consists of 8 terminations in total.As far as functions are concerned, the lighting driver has 1.It is necessary to reduce the maximum output current to 1A to meet the operation criteria.It is possible to obtain high efficiency with a supply voltage of 5V.In this LED driver, the maximum supply voltage is configured to be 5.5V (Vsup).In order for this lighting driver to operate normally, the supply voltage (Vsup) should remain above 2.7V.
BD82000FVJ-LBE2 Features
Supplied from 5V
BD82000FVJ-LBE2 Applications
There are a lot of ROHM Semiconductor BD82000FVJ-LBE2 Power Switches ICs applications.
- USB3.1 Power Delivery
- Hot Swap
- Notebook and Tablet Computers
- Telecom and Network Systems
- Set-top-box
- Storage Drives
- Wireless/Networking Cards
- Solid-State Drives
- Gaming
- USB Protection
