BD82061FVJ-LBE2
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mounting Type | Surface Mount |
| Package / Case | 8-TSSOP, 8-MSOP (0.118, 3.00mm Width) |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Cut Tape (CT) |
| Published | 2014 |
| Feature | Slew Rate Controlled, Status Flag |
| Part Status | Discontinued |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| ECCN Code | EAR99 |
| Peak Reflow Temperature (Cel) | NOT SPECIFIED |
| Time@Peak Reflow Temperature-Max (s) | NOT SPECIFIED |
| Number of Outputs | 1 |
| Output Type | N-Channel |
| Max Output Current | 1.5A |
| Interface | On/Off |
| Output Configuration | High Side |
| Voltage - Supply (Vcc/Vdd) | Not Required |
| Input Type | Non-Inverting |
| Switch Type | USB Switch |
| Ratio - Input:Output | 1:1 |
| Voltage - Load | 2.7V~5.5V |
| Fault Protection | Current Limiting (Fixed), Over Temperature, Reverse Current, UVLO |
| Rds On (Typ) | 70m Ω |
| RoHS Status | ROHS3 Compliant |
BD82061FVJ-LBE2 Overview
The LED driver's packaged as a Cut Tape (CT).There is a 8-TSSOP, 8-MSOP (0.118, 3.00mm Width) package that includes it.The lighting driver has the mounting type Surface Mount.There is a switch type of USB Switch.To ensure reliable operation, the temperature should be set to -40°C~85°C TA.There is a default setting of 1 for output.In order to operate, it requires a voltage supply of Not Required.A maximum output voltage of N-Channel volts has been specified.As far as features are concerned, the LED driving board has Slew Rate Controlled, Status Flag.This operation requires the maximum output current to be decreased to 1.5A.
BD82061FVJ-LBE2 Features
BD82061FVJ-LBE2 Applications
There are a lot of ROHM Semiconductor BD82061FVJ-LBE2 Power Switches ICs applications.
- Portable Devices
- Handheld Devices
- Notebook PC
- Wearable Devices
- Low Voltage I/O System Power
- PC Card Hot Swap
- Various applications equipped with buttons
- Portable GPS
- Hot Swap
- Solid-State Drives
