BD8LB600FS-CE2
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mounting Type | Surface Mount |
| Package / Case | 24-SOP (0.213, 5.40mm Width) |
| Surface Mount | YES |
| Operating Temperature | -40°C~150°C TJ |
| Packaging | Cut Tape (CT) |
| Published | 2015 |
| Series | Automotive, AEC-Q100 |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 24 |
| ECCN Code | EAR99 |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | NOT SPECIFIED |
| Number of Functions | 1 |
| Supply Voltage | 5V |
| Time@Peak Reflow Temperature-Max (s) | NOT SPECIFIED |
| JESD-30 Code | R-PDSO-G24 |
| Number of Outputs | 8 |
| Output Type | N-Channel |
| Supply Voltage-Min (Vsup) | 4V |
| Interface | SPI |
| Current - Output (Max) | 1A |
| Output Configuration | Low Side |
| Voltage - Supply (Vcc/Vdd) | 3V~5.5V |
| Input Type | Non-Inverting |
| Switch Type | General Purpose |
| Nominal Input Voltage | 5.5V |
| Ratio - Input:Output | 4:8 |
| Voltage - Load | 3V~5.5V |
| Fault Protection | Current Limiting (Fixed), Open Load Detect, Over Temperature, UVLO |
| Turn On Time | 50 µs |
| Rds On (Typ) | 1.1 Ω |
| Turn Off Time | 50 µs |
| Built-in Protections | OVER CURRENT; OVER VOLTAGE; UNDER VOLTAGE |
| Output Current Flow Direction | SINK |
| Height Seated (Max) | 2.1mm |
| Length | 10mm |
| Width | 5.4mm |
| RoHS Status | ROHS3 Compliant |
BD8LB600FS-CE2 Overview
It's?packaged?in?the way?of?a?Cut Tape (CT).This package is included in 24-SOP (0.213, 5.40mm Width).This lighting drivere has a mounting type of Surface Mount.General Purpose is the type of switch owned by it.It is recommended that the temperature be set to -40°C~150°C TJ for reliable operation.It is possible to use 8 outputs in the lighting driver.Operation is based on 3V~5.5V supply voltage.A maximum output voltage of N-Channel volts has been specified.A total of 24 terminations have been found in it.It consists of 1 functions.The maximum output of the LED driving board is 1AV.It is possible to obtain high efficiency with a supply voltage of 5V.These electrical components are part of the Automotive, AEC-Q100 series.The supply voltage (Vsup) should be kept above 4V for normal operation.
BD8LB600FS-CE2 Features
Supplied from 5V
BD8LB600FS-CE2 Applications
There are a lot of ROHM Semiconductor BD8LB600FS-CE2 Power Switches ICs applications.
- HDD, SSD
- Set-Top Boxes
- PDAs
- Hot-Swap Systems
- Handheld Devices
- Portable Video Game Players
- Portable/Handheld Devices
- Portable GPS Device
- USB3.1 Power Delivery
- USB Power Distribution
