Parameters |
Surface Mount |
YES |
Number of Pins |
8 |
Weight |
10.886217mg |
Packaging |
Tape & Reel (TR) |
JESD-609 Code |
e4 |
Pbfree Code |
yes |
Moisture Sensitivity Level (MSL) |
2 |
Number of Terminations |
8 |
ECCN Code |
EAR99 |
Terminal Finish |
Nickel/Palladium/Gold (Ni/Pd/Au) |
Max Operating Temperature |
125°C |
Min Operating Temperature |
0°C |
Subcategory |
Power Management Circuits |
Terminal Position |
DUAL |
Peak Reflow Temperature (Cel) |
260 |
Number of Functions |
1 |
Supply Voltage |
4V |
Terminal Pitch |
0.5mm |
Pin Count |
8 |
Power Supplies |
3.3/30V |
Number of Channels |
1 |
Max Supply Voltage |
26V |
Min Supply Voltage |
3.3V |
Analog IC - Other Type |
POWER SUPPLY SUPPORT CIRCUIT |
Adjustable Threshold |
NO |
Voltage - Output |
5V |
Supply Current-Max (Isup) |
0.5mA |
Length |
2mm |
Width |
2mm |
Radiation Hardening |
No |
RoHS Status |
RoHS Compliant |
Lead Free |
Contains Lead |
BQ24305DSGRG4 Overview
Analog IC POWER SUPPLY SUPPORT CIRCUIT is used in this device. A total of 1 channels are available. There are 8 pins on it. Tape & Reel (TR) is the case number of the package. The minimum supply voltage for this part should not be less than 3.3V volts. The Power Management Circuits family of electrical components includes this component. A voltage of 26V volts is recommended for this chip. It should not be less than 0°C in order to activate this device. A temperature below 125°C is suggested for use. There is a 3.3/30V volt power source. This device should always be set to 4V. There are a total of 8 pins on it. A maximum of 0.5mA current must be available from the supply (Isup). The output voltage of the device is 5V.
BQ24305DSGRG4 Features
with 8 Pins
operate supply voltage at the range of 4V
BQ24305DSGRG4 Applications
There are a lot of Texas Instruments BQ24305DSGRG4 Battery Management ICs applications.
- ADAS Lidar
- Grid support
- Aviation ground support systems
- Infotainment/cluster
- Consumer electronics
- Non-road type vehicles
- Solar and wind-generating plants
- Buses
- Rear light with dynamic control
- Motor drive - 3 phase AC100V-240V AC servo