BSP752RNUMA1
| Parameters | |
|---|---|
| Mounting Type | Surface Mount |
| Package / Case | 8-SOIC (0.154, 3.90mm Width) |
| Surface Mount | YES |
| Operating Temperature | -40°C~150°C TJ |
| Packaging | Tape & Reel (TR) |
| Series | Automotive, AEC-Q100 |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 8 |
| ECCN Code | EAR99 |
| Technology | MOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Number of Functions | 1 |
| Supply Voltage | 13.5V |
| Pin Count | 8 |
| JESD-30 Code | R-PDSO-G8 |
| Number of Outputs | 1 |
| Qualification Status | Not Qualified |
| Output Type | N-Channel |
| Supply Voltage-Max (Vsup) | 52V |
| Supply Voltage-Min (Vsup) | 6V |
| Interface | On/Off |
| Current - Output (Max) | 1.3A |
| Output Configuration | High Side |
| Voltage - Supply (Vcc/Vdd) | Not Required |
| Input Type | Non-Inverting |
| Switch Type | General Purpose |
| Ratio - Input:Output | 1:1 |
| Voltage - Load | 6V~52V |
| Fault Protection | Current Limiting (Fixed), Open Load Detect, Over Temperature, Over Voltage |
| Output Peak Current Limit-Nom | 1.7A |
| Rds On (Typ) | 150m Ω |
| Turn Off Time | 200 µs |
| Built-in Protections | TRANSIENT; OVER CURRENT; OVER VOLTAGE; THERMAL; UNDER VOLTAGE |
| Output Current Flow Direction | SINK |
| Length | 5mm |
| Width | 4mm |
BSP752RNUMA1 Overview
It's?packaged?in?the way?of?a?Tape & Reel (TR).The 8-SOIC (0.154, 3.90mm Width) package contains it.The LED driver is mounted as Surface Mount.The switch type is General Purpose.To ensure reliable operation, the temperature should be set to -40°C~150°C TJ.The LED driver has a total of 1 outputs.Operation is based on Not Required supply voltage.There is a maximum output voltage of N-Channel volts.As a result, there are 8 terminations.As far as the lighting driver is concerned, there are 1 functions.From the lighting driver, there is a maximum output of 1.3AV.High efficiency is possible when the supply voltage is set to 13.5V.This LED driver is equipped with a total of 8 pins.This electrical component can be found in the Automotive, AEC-Q100 series.The lighting driver is configured to have a maximum supply voltage of 52V (Vsup).In order for the lighting driver to operate normally, the supply voltage (Vsup) should be maintained above 6V.
BSP752RNUMA1 Features
Supplied from 13.5V
BSP752RNUMA1 Applications
There are a lot of Infineon Technologies BSP752RNUMA1 Power Switches ICs applications.
- Hot Swap
- USB3.1 Power Delivery
- Various applications equipped with buttons
- Wireless Modem Data Cards
- Set-top-box
- Storage Drives
- PC Card Hot Swap
- Mobile Communication Devices
- Wearable Devices
- Solid State Drivers
