Parameters |
Factory Lead Time |
1 Week |
Mounting Type |
Surface Mount |
Package / Case |
TO-252-3, DPak (2 Leads + Tab), SC-63 |
Surface Mount |
YES |
Operating Temperature |
-40°C~150°C TJ |
Packaging |
Tape & Reel (TR) |
Published |
2017 |
Series |
HITFET® |
Feature |
Auto Restart |
Pbfree Code |
yes |
Part Status |
Active |
Moisture Sensitivity Level (MSL) |
1 (Unlimited) |
Number of Terminations |
2 |
ECCN Code |
EAR99 |
Terminal Position |
SINGLE |
Terminal Form |
GULL WING |
Peak Reflow Temperature (Cel) |
NOT SPECIFIED |
Number of Functions |
1 |
Supply Voltage |
5V |
Terminal Pitch |
2.28mm |
Time@Peak Reflow Temperature-Max (s) |
NOT SPECIFIED |
JESD-30 Code |
R-PSSO-G2 |
Number of Outputs |
1 |
Output Voltage |
40V |
Output Type |
N-Channel |
Supply Voltage-Min (Vsup) |
3V |
Interface |
On/Off |
Current - Output (Max) |
5A |
Output Configuration |
Low Side |
Voltage - Supply (Vcc/Vdd) |
Not Required |
Input Type |
Non-Inverting |
Switch Type |
General Purpose |
Nominal Input Voltage |
5.5V |
Ratio - Input:Output |
1:1 |
Voltage - Load |
40V Max |
Fault Protection |
Current Limiting (Fixed), Over Temperature, Over Voltage |
Output Peak Current Limit-Nom |
5A |
Rds On (Typ) |
30m Ω |
Built-in Protections |
TRANSIENT; OVER CURRENT; OVER VOLTAGE; THERMAL |
Output Current Flow Direction |
SINK |
Height Seated (Max) |
2.5mm |
Length |
6.5mm |
Width |
6.22mm |
RoHS Status |
ROHS3 Compliant |
BTS3035TFATMA1 Overview
As a result, it is packaged in the form of a Tape & Reel (TR).This file is included in package TO-252-3, DPak (2 Leads + Tab), SC-63.The LED driver is mounted as Surface Mount.General Purpose is the type of switch owned by it.It is recommended that the temperature be set to -40°C~150°C TJ for reliable performance.The LED driver has a total of 1 outputs.It uses a supply voltage of Not Required to operate.A maximum output voltage of N-Channel volts has been specified.It is equipped with Auto Restart features.It consists of 2 terminations in total.Currently, the lighting driver has a total of 1 functions.The LED driver output is limited to 5AV.High efficiency is possible at 5V supply voltage.It is part of the HITFET? series.In order for the lighting driver to operate normally, the supply voltage (Vsup) should be maintained above 3V.
BTS3035TFATMA1 Features
Supplied from 5V
BTS3035TFATMA1 Applications
There are a lot of Infineon Technologies BTS3035TFATMA1 Power Switches ICs applications.
- Storage (HDDs, SSDs)
- Portable Music Players
- USB Power Distribution
- Portable GPS Device
- Set-Top Boxes
- Hot-Swap Systems
- Wireless/Networking Cards
- HDD and SSD
- PDAs
- Notebook and Tablet Computers