CAT150049SWI-GT3
| Parameters | |
|---|---|
| Lifecycle Status | LAST SHIPMENTS (Last Updated: 4 days ago) |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 8-SOIC (0.154, 3.90mm Width) |
| Number of Pins | 8 |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tape & Reel (TR) |
| Published | 2007 |
| JESD-609 Code | e4 |
| Pbfree Code | yes |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 8 |
| ECCN Code | EAR99 |
| Type | Simple Reset/Power-On Reset |
| Terminal Finish | Nickel/Palladium/Gold (Ni/Pd/Au) |
| Subcategory | EEPROMs |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Supply Voltage | 3.3V |
| Time@Peak Reflow Temperature-Max (s) | 40 |
| Base Part Number | CAT15004 |
| Output | Push-Pull, Totem Pole |
| Pin Count | 8 |
| Power Supplies | 3.3V |
| Max Supply Voltage | 5.5V |
| Min Supply Voltage | 2.5V |
| Operating Supply Current | 2mA |
| Max Supply Current | 2mA |
| Watchdog Timer | No |
| Reset | Active Low |
| Voltage - Threshold | 2.93V |
| Number of Voltages Monitored | 1 |
| Reset Timeout | 140ms Minimum |
| Halogen Free | Halogen Free |
| Memory Width | 1 |
| Min Reset Threshold Voltage | 2.89V |
| Max Reset Threshold Voltage | 2.96V |
| Standby Current-Max | 0.00002A |
| Memory Density | 4096 bit |
| Undervoltage Threshold | 2.89V |
| Overvoltage Threshold | 2.96V |
| Parallel/Serial | SERIAL |
| Write Cycle Time-Max (tWC) | 5ms |
| Data Retention Time-Min | 100 |
| Write Protection | HARDWARE |
| Length | 4.9mm |
| Width | 3.9mm |
| RoHS Status | RoHS Compliant |
| Lead Free | Lead Free |
CAT150049SWI-GT3 Overview
As you can see, this power management is mounted through 8 terminals. Packaging is in the form of a Tape & Reel (TR). In this IC power you will find 1 functions for you to refer to. In this PMIC, you can find 8-SOIC (0.154, 3.90mm Width) functions for your reference. As with other Simple Reset/Power-On Reset products, this IC management also offers a wide range of benefits. IC management is specified that the package peak reflow temperature should be 260. During operation, the power ic is supplied with a voltage of 3.3V. Power ics operate at 1 supply voltages. By Surface Mount, IC management has been mounted. It is possible to subcategorize this power ic as a EEPROMs chip. The total number of pins on this power management is 8. Power managment ic pin count is 8. It is recommended that Vsup should not be less than 2.5V for this IC power. During this IC power, the maximum supply voltage (Vsup) should not exceed 5.5V volts. In this case, Surface Mount is the recommended mounting type. It is recommended to set the supervisor's temperature to this range: -40°C~85°C TA. During operation, this power management system outputs Push-Pull, Totem Pole. There is a supply current of 2mA for the power management. For similar manage ics search of the manufacturer, you can always refer to CAT15004, the base PMIC number. There is a requirement for 3.3V power to power this power management. The maximum supply temperature that PMIC chip can work with is 2mA.
CAT150049SWI-GT3 Features
Simple Reset/Power-On Reset type
Minimum supply voltage of 2.5V
2mA operating supply current
CAT150049SWI-GT3 Applications
There are a lot of ON Semiconductor CAT150049SWI-GT3 Voltage Supervisors applications.
- Leakage current detection
- Urban rail transit weak current power monitoring
- DVR
- Detection of phase imbalance
- Radar
- Medical-specific isolation transformer
- Dash board
- Consumer electronics
- Electrical fire monitoring system
- Multi-voltage system
