CD74HC173E
| Parameters | |
|---|---|
| Mounting Type | Through Hole |
| Package / Case | 16-DIP (0.300, 7.62mm) |
| Surface Mount | NO |
| Operating Temperature | -55°C~125°C TA |
| Packaging | Tube |
| Series | 74HC |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 3 (168 Hours) |
| Number of Terminations | 16 |
| Type | D-Type |
| Additional Feature | WITH HOLD MODE; WITH DUAL OUTPUT ENABLE |
| Technology | CMOS |
| Voltage - Supply | 2V~6V |
| Terminal Position | DUAL |
| Supply Voltage | 4.5V |
| Function | Master Reset |
| Qualification Status | Not Qualified |
| Output Type | Tri-State, Non-Inverted |
| Number of Elements | 1 |
| Supply Voltage-Max (Vsup) | 6V |
| Supply Voltage-Min (Vsup) | 2V |
| Clock Frequency | 60MHz |
| Family | HC/UH |
| Current - Quiescent (Iq) | 8μA |
| Output Characteristics | 3-STATE |
| Current - Output High, Low | 7.8mA 7.8mA |
| Output Polarity | TRUE |
| Number of Bits per Element | 4 |
| Max Propagation Delay @ V, Max CL | 34ns @ 6V, 50pF |
| Trigger Type | Positive Edge |
| Input Capacitance | 10pF |
| Propagation Delay (tpd) | 300 ns |
| RoHS Status | Non-RoHS Compliant |
CD74HC173E Overview
The flip flop is packaged in a case of 16-DIP (0.300, 7.62mm). A package named Tubeincludes it. The output it is configured with uses Tri-State, Non-Inverted. This trigger uses the value Positive Edge. Through Holeis occupied by this electronic component. It operates with a supply voltage of 2V~6V. Currently, the operating temperature is -55°C~125°C TA. It is an electronic flip flop with the type D-Type. In this case, it is a type of FPGA belonging to the 74HC series. A frequency of 60MHzshould not be exceeded by its output. In total, there are 1 elements. As a result, it consumes 8μA of quiescent current without being affected by external factors. A total of 16terminations have been recorded. It is powered by a voltage of 4.5V . This JK flip flop has a 10pFfarad input capacitance. An electronic device belonging to the family HC/UHcan be found here. It reaches 6Vwhen the supply voltage is maximal (Vsup). The supply voltage (Vsup) should be maintained above 2V for normal operation. Additionally, you may refer to the D latch's additional WITH HOLD MODE; WITH DUAL OUTPUT ENABLE.
CD74HC173E Features
Tube package
74HC series
CD74HC173E Applications
There are a lot of Rochester Electronics, LLC CD74HC173E Flip Flops applications.
- Single Up Count-Control Line
- Individual Asynchronous Resets
- Pattern generators
- Frequency division
- Data storage
- Shift Registers
- Consumer
- Memory
- ESD performance
- Cold spare funcion
