CD74HC574E
| Parameters | |
|---|---|
| Mounting Type | Through Hole |
| Package / Case | 20-DIP (0.300, 7.62mm) |
| Surface Mount | NO |
| Operating Temperature | -55°C~125°C TA |
| Packaging | Tube |
| Series | 74HC |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 3 (168 Hours) |
| Number of Terminations | 20 |
| Type | D-Type |
| Additional Feature | BROADSIDE VERSION OF 374 |
| Technology | CMOS |
| Voltage - Supply | 2V~6V |
| Terminal Position | DUAL |
| Supply Voltage | 5V |
| JESD-30 Code | R-PDIP-T20 |
| Function | Standard |
| Qualification Status | COMMERCIAL |
| Output Type | Tri-State, Non-Inverted |
| Number of Elements | 1 |
| Supply Voltage-Max (Vsup) | 6V |
| Supply Voltage-Min (Vsup) | 2V |
| Number of Ports | 2 |
| Clock Frequency | 60MHz |
| Family | HC/UH |
| Current - Quiescent (Iq) | 8μA |
| Output Characteristics | 3-STATE |
| Current - Output High, Low | 7.8mA 7.8mA |
| Output Polarity | TRUE |
| Number of Bits per Element | 8 |
| Max Propagation Delay @ V, Max CL | 28ns @ 6V, 50pF |
| Trigger Type | Positive Edge |
| Input Capacitance | 10pF |
| Propagation Delay (tpd) | 250 ns |
| RoHS Status | Non-RoHS Compliant |
CD74HC574E Overview
In the form of 20-DIP (0.300, 7.62mm), it has been packaged. As part of the package Tube, it is embedded. Currently, the output is configured to use Tri-State, Non-Inverted. It is configured with the trigger Positive Edge. The electronic part is mounted in the way of Through Hole. A supply voltage of 2V~6V is required for operation. Currently, the operating temperature is -55°C~125°C TA. There is D-Type type of electronic flip flop associated with this device. In this case, it is a type of FPGA belonging to the 74HC series. This D flip flop should not have a frequency greater than 60MHz. In total, it contains 1 elements. Despite external influences, it consumes 8μAof quiescent current. There are 20 terminations, which are the practice of ending a transmission line with a device that matches the characteristic impedance of the line. The power supply voltage is 5V. This T flip flop has a capacitance of 10pF farads at the input. An electronic device belonging to the family HC/UHcan be found here. There is a 6Vmaximum supply voltage (Vsup). Normally, the supply voltage (Vsup) should be kept above 2V. The flip flop has 2ports embedded within it. Additionally, there are BROADSIDE VERSION OF 374 on the electronic flip flop that can be referred to.
CD74HC574E Features
Tube package
74HC series
CD74HC574E Applications
There are a lot of Rochester Electronics, LLC CD74HC574E Flip Flops applications.
- Frequency Divider circuits
- Storage Registers
- Matched Rise and Fall
- 2 – Bit synchronous counter
- Consumer
- Differential Individual
- Balanced 24 mA output drivers
- Synchronous counter
- Event Detectors
- Reduced system switching noise
