CP82C54-10
| Parameters | |
|---|---|
| Contact Plating | Lead, Tin |
| Mount | Through Hole |
| Package / Case | PDIP |
| Number of Pins | 24 |
| Packaging | Bulk |
| Published | 1996 |
| Part Status | Active |
| Max Operating Temperature | 70°C |
| Min Operating Temperature | 0°C |
| Frequency | 10MHz |
| Operating Supply Voltage | 5V |
| Max Supply Voltage | 5.5V |
| Min Supply Voltage | 4.5V |
| Operating Supply Current | 10mA |
| Nominal Supply Current | 10mA |
| Propagation Delay | 100 ns |
| Number of Timers/Counters | 6 |
| High Level Output Current | -2.5mA |
| Low Level Output Current | 2.5mA |
| RoHS Status | Non-RoHS Compliant |
| Lead Free | Contains Lead |
CP82C54-10 Overview
The timer clock is enclosed in a packaging that is attached to the PDIP. Frequency is set to 10MHz on the programmable timer.It is used to pack in Bulk case. To mount this digital timer with Through Hole. The operating supply voltage is rated at 10mA voltage. The minimum operating temperature of the chip must not be lower than 0°C. It's best to use the timer clock when the temperature is below 70°C. The timer clock contains 24 pins. The digital timer's operating supply voltage is rated 5V voltage. The minimum supply voltage of the chip must not be lower than 4.5V. The supply voltage of this chip should not exceed 5.5V. The number of Timers/Counters on the device is 6.
CP82C54-10 Features
Operate frequency at 10MHz
Package / Case: Bulk
Max Operating temperature at 0°C
6 Timers/Counters
CP82C54-10 Applications
There are a lot of Intersil (Renesas Electronics America) CP82C54-10 Programmable Timers & Oscillators applications.
- Remote current sensor
- Safety and Security Platforms
- Remote Sensors
- Precision timing
- Low-Power Wireless
- Delay circuits
- Intruder Detection
- Sensor Node
- Clutch Actuator circuit
- Watchdog Timers
