CP82C54-12Z
| Parameters | |
|---|---|
| Number of Timers/Counters | 1 |
| High Level Output Current | -2.5mA |
| External Data Bus Width | 8 |
| Low Level Output Current | 2.5mA |
| Information Access Method | PARALLEL, DIRECT ADDRESS |
| Height Seated (Max) | 6.35mm |
| RoHS Status | RoHS Compliant |
| Lead Free | Lead Free |
| Factory Lead Time | 1 Week |
| Contact Plating | Tin |
| Mount | Through Hole |
| Package / Case | PDIP |
| Number of Pins | 24 |
| Packaging | Bulk |
| Published | 1996 |
| JESD-609 Code | e3 |
| Pbfree Code | yes |
| Part Status | Active |
| Number of Terminations | 24 |
| ECCN Code | EAR99 |
| Max Operating Temperature | 70°C |
| Min Operating Temperature | 0°C |
| Technology | CMOS |
| Terminal Position | DUAL |
| Peak Reflow Temperature (Cel) | NOT APPLICABLE |
| Supply Voltage | 5V |
| Terminal Pitch | 2.54mm |
| Frequency | 12MHz |
| Time@Peak Reflow Temperature-Max (s) | NOT APPLICABLE |
| Pin Count | 24 |
| Qualification Status | Not Qualified |
| Operating Supply Voltage | 5V |
| Temperature Grade | COMMERCIAL |
| Max Supply Voltage | 5.5V |
| Min Supply Voltage | 4.5V |
| Operating Supply Current | 10mA |
| uPs/uCs/Peripheral ICs Type | TIMER, PROGRAMMABLE |
| Number of Bits | 16 |
| Propagation Delay | 100 ns |
CP82C54-12Z Overview
A PDIP box encloses the digital timer. Set the frequency of the timer to 12MHz.It is used to pack in Bulk case. To mount this digital timer with Through Hole. The operating supply voltage is rated at 10mA voltage. The minimum operating temperature of the chip must not be lower than 0°C. It's best to use the timer clock when the temperature is below 70°C. The timer clock contains 24 pins. The digital timer's operating supply voltage is rated 5V voltage. The supply voltage of the programmable timer can rate 5V. The sum of the IC chip pins is 24 . The number of the chip's terminations sums up to 24. The minimum supply voltage of the chip must not be lower than 4.5V. The supply voltage of this chip should not exceed 5.5V. The number of Timers/Counters on the device is 1.
CP82C54-12Z Features
Operate frequency at 12MHz
Package / Case: Bulk
Max Operating temperature at 0°C
1 Timers/Counters
CP82C54-12Z Applications
There are a lot of Intersil (Renesas Electronics America) CP82C54-12Z Programmable Timers & Oscillators applications.
- Car Door Handle circuit
- Watchdog Timers
- Intruder Detection
- Power-On Reset Timer
- Remote current sensor
- High Vibration, High Acceleration Environments
- Building Automation
- Intruder Detection
- Power-Gating Applications
- Clutch Actuator circuit
