Parameters |
Factory Lead Time |
1 Week |
Contact Plating |
Tin |
Mount |
Surface Mount |
Mounting Type |
Surface Mount |
Package / Case |
16-SOIC (0.154, 3.90mm Width) |
Number of Pins |
16 |
Weight |
547.485991mg |
Operating Temperature |
-40°C~85°C TA |
Packaging |
Tube |
Published |
2005 |
JESD-609 Code |
e3 |
Pbfree Code |
yes |
Part Status |
Active |
Moisture Sensitivity Level (MSL) |
1 (Unlimited) |
Number of Terminations |
16 |
Resistance |
85Ohm |
Subcategory |
Multiplexer or Switches |
Max Power Dissipation |
640mW |
Technology |
CMOS |
Terminal Form |
GULL WING |
Peak Reflow Temperature (Cel) |
260 |
Number of Functions |
4 |
Supply Voltage |
15V |
Terminal Pitch |
1.27mm |
Time@Peak Reflow Temperature-Max (s) |
40 |
Base Part Number |
DG211 |
Pin Count |
16 |
Polarity |
Non-Inverting |
Power Supplies |
512/+-15V |
Number of Channels |
1 |
Voltage |
44V |
Max Supply Voltage |
25V |
Min Supply Voltage |
4.5V |
Operating Supply Current |
10μA |
Nominal Supply Current |
50μA |
Power Dissipation |
640mW |
Max Supply Current |
10μA |
Throw Configuration |
SPST |
Turn On Delay Time |
300 ns |
Number of Inputs |
4 |
Voltage - Supply, Single/Dual (±) |
4.5V~25V ±4.5V~22V |
Supply Type |
Dual, Single |
Neg Supply Voltage-Nom (Vsup) |
-15V |
Turn-Off Delay Time |
200 ns |
Max Dual Supply Voltage |
22V |
On-State Resistance (Max) |
85Ohm |
Min Dual Supply Voltage |
4.5V |
High Level Output Current |
100mA |
Multiplexer/Demultiplexer Circuit |
1:1 |
Off-state Isolation-Nom |
90 dB |
Current - Leakage (IS(off)) (Max) |
500pA |
Channel Capacitance (CS(off), CD(off)) |
5pF 5pF |
On-state Resistance Match-Nom |
2Ohm |
Switch Circuit |
SPST - NC |
Switch Time (Ton, Toff) (Max) |
300ns, 200ns |
Charge Injection |
1pC |
Channel-to-Channel Matching (ΔRon) |
2 Ω |
Crosstalk |
-95dB @ 100kHz |
Switching |
BREAK-BEFORE-MAKE |
Drain to Source Resistance |
85Ohm |
Normal Position |
NC |
Height |
1.55mm |
Length |
10mm |
Width |
4mm |
Radiation Hardening |
No |
REACH SVHC |
Unknown |
RoHS Status |
ROHS3 Compliant |
Lead Free |
Lead Free |
DG211BDY-E3 Overview
Presented in 16-SOIC (0.154, 3.90mm Width), this electrical component is convenient for overseas shipping. High reliability is provided by advanced packaging method Tube. Surface Mount is where this multiplexer is located. Multiplexers and demultiplexers have the same number of circuits 1:1. Temperatures around -40°C~85°C TA are extended for operation. In total, there are 16 terminations. This electronic part offers high-quality output due to its 1 channels. In the case of a voltage supply of 15V volts, the electrical part can be powered up and run. There is an electrical component included in the 16 series. Unlike digital switches, these are based on SPST - NC switching circuits. Use DG211 to search for variants of the digital switches. It has an internal resistance of 85Ohm. For details about the functions of 16 pins, please refer to the datasheets. The analog multiplexer shown here is a typical Multiplexer or Switches. In a normalsituation, users should not supply the switches with voltage higher than 25V. A cost-effective Dual, Single supply type analogue multiplexer. It is recommended to use 4.5V as the lowest voltage for the electrical part. The switch device would be able to operate with 10μA current. Putting voltage greater than 10μA on the multiplexer may cause damage. Despite this switch's dual supply capability, its voltage should not exceed 22V. For dual power supplies, a voltage of at least 4.5V should be attached. Among the inputs that can be operated are the 4 inputs. There is 85Ohm resistance between the Drain and Source on this part.
DG211BDY-E3 Features
1 Channels
Switch Circuit: SPST - NC
10μA Supply Current
Drain-to-Source resistance: 85Ohm
DG211BDY-E3 Applications
There are a lot of Vishay Siliconix DG211BDY-E3 Analog Switches & Multiplexers ICs applications.
- Precision instrumentation
- Transmit
- Routers
- Industrial
- T1/E1 Terminals
- Public switching systems
- SONET
- Precision data acquisition
- Residential Gateways, Home Gateway/Router
- Mechanical reed relay replacement