DG212EUE+
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 16-TSSOP (0.173, 4.40mm Width) |
| Number of Pins | 16 |
| Operating Temperature | 0°C~70°C TA |
| Packaging | Tube |
| Published | 2006 |
| JESD-609 Code | e3 |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Resistance | 175Ohm |
| Terminal Finish | Matte Tin (Sn) |
| Max Power Dissipation | 755mW |
| Base Part Number | DG212 |
| Number of Circuits | 4 |
| Max Supply Voltage | 18V |
| Min Supply Voltage | 4.5V |
| Operating Supply Current | 20μA |
| Nominal Supply Current | 20μA |
| Max Supply Current | 400μA |
| Throw Configuration | SPST |
| Turn On Delay Time | 1 μs |
| Supply Type | Dual |
| Turn-Off Delay Time | 500 ns |
| Max Dual Supply Voltage | 18V |
| On-State Resistance (Max) | 175Ohm |
| Min Dual Supply Voltage | 4.5V |
| Multiplexer/Demultiplexer Circuit | 1:1 |
| Current - Leakage (IS(off)) (Max) | 5nA |
| Channel Capacitance (CS(off), CD(off)) | 5pF 5pF |
| Switch Circuit | SPST - NO |
| Switch Time (Ton, Toff) (Max) | 1μs, 500ns |
| Crosstalk | -90dB @ 100kHz |
| Voltage - Supply, Dual (V±) | ±4.5V~18V |
| Radiation Hardening | No |
| RoHS Status | ROHS3 Compliant |
DG212EUE+ Overview
The electronic part can be shipped overseas conveniently because it is packaged in 16-TSSOP (0.173, 4.40mm Width). This packaging method provides high reliability because it uses advanced packaging techniques. Surface Mount is where this multiplexer is located. Multiplexers and demultiplexers have the same number of circuits 1:1. Around 0°C~70°C TA is the extended operating temperature. SPST - NO switching circuits are used in these analog switch ics. The circuits in this analogue multiplexer number 4. Try searching for DG212 variants of the analog switch ic. There is 175Ohm internal resistance in this digital multiplexer. You can find the functions of the 16 pins in the datasheets. normally, users should not supply switches with voltages higher than 18V. Analogue multiplexer with a Dual supply type that is cost-effective. There should be 4.5V voltage fed to the electrical part below 4.5V. This multiplexer would work with 20μA current. A digital multiplexer may suffer damage if voltage is applied above 400μA. Despite this switch's dual supply capability, its voltage should not exceed 18V. It is recommended that you attach at least 4.5V to your dual power supply.
DG212EUE+ Features
Switch Circuit: SPST - NO
20μA Supply Current
DG212EUE+ Applications
There are a lot of Maxim Integrated DG212EUE+ Analog Switches & Multiplexers ICs applications.
- Optical Applications
- E1 Network Equipment
- Audio/video switches
- Communications systems
- Switching Systems
- Industrial and process control systems
- High reliability control systems
- Precision instrumentation
- DSLAMs
- PBXs
