DG2522DN-T1-E4
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 8-UFQFN |
| Number of Pins | 8 |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tape & Reel (TR) |
| Published | 2013 |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Resistance | 1.1Ohm |
| Max Power Dissipation | 190mW |
| Base Part Number | DG2522 |
| Number of Circuits | 1 |
| Max Supply Voltage | 5.5V |
| Min Supply Voltage | 1.6V |
| Operating Supply Current | 1μA |
| Max Supply Current | 1μA |
| Turn On Delay Time | 75 ns |
| Supply Type | Single |
| Turn-Off Delay Time | 60 ns |
| -3db Bandwidth | 105MHz |
| On-State Resistance (Max) | 1.1Ohm |
| Multiplexer/Demultiplexer Circuit | 3:1 |
| Current - Leakage (IS(off)) (Max) | 20nA |
| Channel Capacitance (CS(off), CD(off)) | 51pF |
| Switch Circuit | SP3T |
| Switch Time (Ton, Toff) (Max) | 75ns, 60ns |
| Charge Injection | 27pC |
| Channel-to-Channel Matching (ΔRon) | 100m Ω (Max) |
| Crosstalk | -64dB @ 1MHz |
| Voltage - Supply, Single (V+) | 1.6V~5.5V |
| RoHS Status | ROHS3 Compliant |
DG2522DN-T1-E4 Overview
The electrical component comes in 8-UFQFN packaging, which makes it convenient to ship overseas. In order to provide high reliability, an advanced packaging method Tape & Reel (TR) is used. A switch device like this is mounted in Surface Mount. Multiplexers and demultiplexers have a ratio of 3:1. Operating temperature around -40°C~85°C TA extended. A SP3T switching circuit is used for these analog switches. A total of 1 circuits make up this switch device. Try searching with DG2522 if you're looking for variants. The internal resistance of this digital multiplexer is 1.1Ohm. Datasheets for functions of 8 pins are available. An abnormal situation would be for the switch device to be supplied with a voltage greater than 5.5V. Analog switch ics with Single supply type are cost-effective. The lowest voltage fed to the electronic component should be 1.6V. For this multiplexer to operate, 1μA current would be sufficient. A voltage of 1.6V~5.5V is required for this switch device, which drains from a single voltage source. A digital multiplexer may suffer damage if voltage is applied above 1μA.
DG2522DN-T1-E4 Features
Switch Circuit: SP3T
1μA Supply Current
-3db Bandwidth: 105MHz
DG2522DN-T1-E4 Applications
There are a lot of Vishay Siliconix DG2522DN-T1-E4 Analog Switches & Multiplexers ICs applications.
- Modems
- Medical systems
- Video signal routing
- Wireless Local Loop
- Channelized and Unchannelized DS3 applications
- Medical Instrumentation
- Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads
- Automatic test equipment
- Multiplexers
- Microprocessor controlled systems
