DG301BDJ
| Parameters | |
|---|---|
| Mounting Type | Through Hole |
| Package / Case | 14-DIP (0.300, 7.62mm) |
| Number of Pins | 14 |
| Weight | 1.620005g |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tube |
| Published | 2016 |
| Pbfree Code | no |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Resistance | 50Ohm |
| Max Power Dissipation | 470mW |
| Reach Compliance Code | unknown |
| Pin Count | 14 |
| Operating Supply Voltage | 15V |
| Number of Circuits | 1 |
| Max Supply Voltage | 36V |
| Min Supply Voltage | 13V |
| Max Supply Current | 1mA |
| Turn On Delay Time | 150 ns |
| Supply Type | Dual, Single |
| Turn-Off Delay Time | 130 ns |
| Max Dual Supply Voltage | 22V |
| On-State Resistance (Max) | 50Ohm |
| Min Dual Supply Voltage | 7V |
| Dual Supply Voltage | 15V |
| Multiplexer/Demultiplexer Circuit | 2:1 |
| Current - Leakage (IS(off)) (Max) | 5nA |
| Channel Capacitance (CS(off), CD(off)) | 14pF 14pF |
| Switch Circuit | SPDT |
| Switch Time (Ton, Toff) (Max) | 150ns, 130ns (Typ) |
| Charge Injection | 8pC |
| Crosstalk | -74dB @ 500kHz |
| Voltage - Supply, Dual (V±) | ±15V |
| Height | 3.81mm |
| Length | 19.3mm |
| Width | 7.11mm |
| RoHS Status | Non-RoHS Compliant |
DG301BDJ Overview
Presented in 14-DIP (0.300, 7.62mm), this electrical component is convenient for overseas shipping. To ensure high reliability, a new packaging method Tube is used. In Through Hole, you'll find this switch device. 2:1 is the ratio of multiplexer to demultiplexer circuits. The operating temperature is extended to around -40°C~85°C TA. A total of 14 pins are injected into the body of the electronic part. These analog multiplexers are built based on SPDT switching circuits. The circuits in this analogue multiplexer number 1. An switch multiplexer with 50Ohm internal resistance has a value of 50Ohm. The datasheets for the 14 pins explain the functions. Multiplexers should not be powered above 36V in normal situations. Dual, Single supply type digital switch with a low cost. 13V is the lowest voltage that should be fed to the electronic electronic part. When the digital multiplexer is charged above 1mA, damage can occur. For this multiplexer, dual supply voltage is feasible, but it should not exceed 22V. For dual power supplies, a voltage of at least 7V should be attached. The electronic component can function from 15V.
DG301BDJ Features
Switch Circuit: SPDT
DG301BDJ Applications
There are a lot of Vishay Siliconix DG301BDJ Analog Switches & Multiplexers ICs applications.
- Audio and video signal routing
- PDH Multiplexers
- SONET/SDH ADM
- Sample-and-hold systems
- Mechanical reed relay replacement
- Microwave transmission systems
- Audio and video routing
- Automotive applications
- Communications systems
- Industrial
