DG309BDJ-E3

200ns, 150ns SPST - NC 85Ohm Analog Switches BREAK-BEFORE-MAKE DG309 16 Pins 500pA 15V 16-DIP (0.300, 7.62mm)

Manufacturer: Vishay Siliconix
Nocochips NO: 880-DG309BDJ-E3
Package: 16-DIP (0.300, 7.62mm)
Datasheet: PDF
Stock: 440
Description: 200ns, 150ns SPST - NC 85Ohm Analog Switches BREAK-BEFORE-MAKE DG309 16 Pins 500pA 15V 16-DIP (0.300, 7.62mm)(Kg)

Details

Tags

Parameters
Factory Lead Time	1 Week
Mount	Through Hole
Mounting Type	Through Hole
Package / Case	16-DIP (0.300, 7.62mm)
Number of Pins	16
Weight	1.627801g
Operating Temperature	-40°C~85°C TA
Packaging	Tube
Published	2005
JESD-609 Code	e3
Pbfree Code	yes
Part Status	Active
Moisture Sensitivity Level (MSL)	1 (Unlimited)
Number of Terminations	16
Resistance	85Ohm
Terminal Finish	Matte Tin (Sn)
Subcategory	Multiplexer or Switches
Max Power Dissipation	470mW
Technology	CMOS
Peak Reflow Temperature (Cel)	NOT SPECIFIED
Number of Functions	4
Supply Voltage	15V
Time@Peak Reflow Temperature-Max (s)	NOT SPECIFIED
Base Part Number	DG309
Output	SEPARATE OUTPUT
Pin Count	16
Qualification Status	Not Qualified
Operating Supply Voltage	22V
Power Supplies	+-15/12V
Number of Channels	1
Max Supply Voltage	44V
Min Supply Voltage	4V
Operating Supply Current	1μA
Power Dissipation	470mW
Max Supply Current	1μA
Throw Configuration	SPST
Turn On Delay Time	200 ns
Number of Inputs	4
Voltage - Supply, Single/Dual (±)	4V~44V ±4V~22V
Supply Type	Dual, Single
Neg Supply Voltage-Nom (Vsup)	-15V
Turn-Off Delay Time	150 ns
Max Dual Supply Voltage	22V
On-State Resistance (Max)	85Ohm
Min Dual Supply Voltage	4V
Multiplexer/Demultiplexer Circuit	1:1
Off-state Isolation-Nom	90 dB
Current - Leakage (IS(off)) (Max)	500pA
Channel Capacitance (CS(off), CD(off))	5pF 5pF
On-state Resistance Match-Nom	1.7Ohm
Switch Circuit	SPST - NC
Switch Time (Ton, Toff) (Max)	200ns, 150ns
Charge Injection	1pC
Channel-to-Channel Matching (ΔRon)	1.7 Ω
Crosstalk	-95dB @ 100kHz
Switching	BREAK-BEFORE-MAKE
Drain to Source Resistance	100Ohm
Normal Position	NC
Height	3.81mm
Length	21.33mm
Width	7.11mm
REACH SVHC	Unknown
RoHS Status	ROHS3 Compliant

DG309BDJ-E3 Overview

Packed in 16-DIP (0.300, 7.62mm), the electronic component is convenient for shipping overseas. High reliability is achieved by using advanced packaging method Tube. Mounted in Through Hole is this multiplexer. Multiplexers and demultiplexers have a ratio of 1:1. The operating temperature is extended to around -40°C~85°C TA. In total, there are 16 terminations. A electrical component with 1 channels is capable of high-quality output. An 15V voltage supply should allow the electrical part to be turned on and run. The electrical component body receives 16 pins. Circuits based on SPST - NC switching are used to construct these analog switch ics. Try searching with DG309 to find analog multiplexer variants. Internally, this switch multiplexer has a resistance of 85Ohm. Datasheets for 16 pin functions are available upon request. It is a typical Multiplexer or Switches analog multiplexer. A voltage higher than 44V should not normally be supplied to the switches. Dual, Single supply type digital switch with a low cost. It is recommended that the electrical component receives a voltage of 4V. It would be sufficient to run this analogue multiplexer with 1μA current. It may damage the digital multiplexer if the voltage is higher than 1μA. For this switch, a dual supply voltage is feasible, but it must not exceed 22VWith dual power supplies, you should attach at least 4V. The outputs of this digital multiplexer are SEPARATE OUTPUT in number. The electronic component can function from 22V. Among the inputs that can be operated are the 4 inputs. There is 100Ohm Drain to Source resistance on this electronic part.