banner_page

DG3537DB-T5-E1

41ns, 37ns SPST - NO/NC 3.5Ohm Analog Switches DG3537 2nA 8-WFBGA


  • Manufacturer: Vishay Siliconix
  • Nocochips NO: 880-DG3537DB-T5-E1
  • Package: 8-WFBGA
  • Datasheet: PDF
  • Stock: 224
  • Description: 41ns, 37ns SPST - NO/NC 3.5Ohm Analog Switches DG3537 2nA 8-WFBGA(Kg)

Details

Tags

Parameters
Factory Lead Time 1 Week
Mount Surface Mount
Mounting Type Surface Mount
Package / Case 8-WFBGA
Number of Pins 8
Supplier Device Package 8-MicroFoot™ (1.5x1.5)
Operating Temperature -40°C~85°C TA
Packaging Tape & Reel (TR)
Published 2008
Part Status Active
Moisture Sensitivity Level (MSL) 1 (Unlimited)
Resistance 4Ohm
Max Operating Temperature 85°C
Min Operating Temperature -40°C
Max Power Dissipation 400mW
Base Part Number DG3537
Number of Circuits 2
Max Supply Voltage 5.5V
Min Supply Voltage 1.8V
Operating Supply Current 1nA
Nominal Supply Current 1nA
Max Supply Current 1μA
Throw Configuration SPST
Turn On Delay Time 46 ns
Supply Type Single
Turn-Off Delay Time 37 ns
-3db Bandwidth 360MHz
On-State Resistance (Max) 3.5Ohm
Multiplexer/Demultiplexer Circuit 1:1
Current - Leakage (IS(off)) (Max) 2nA
Channel Capacitance (CS(off), CD(off)) 8pF
Switch Circuit SPST - NO/NC
Switch Time (Ton, Toff) (Max) 41ns, 37ns
Charge Injection 1pC
Channel-to-Channel Matching (ΔRon) 200mOhm (Max)
Crosstalk -66dB @ 10MHz
Voltage - Supply, Single (V+) 1.8V~5.5V
Radiation Hardening No
RoHS Status ROHS3 Compliant

DG3537DB-T5-E1 Overview


Due to its 8-WFBGA packaging, the electronic part is convenient for international shipping. Advanced packaging method Tape & Reel (TR) is used to provide high reliability. In Surface Mount, you'll find this switch device. Multiplexers and demultiplexers have a ratio of 1:1. Extended operating temperature around -40°C~85°C TA. These analog multiplexers are built based on SPST - NO/NC switching circuits. The multiplexer consists of 2 circuits. Try searching for the analog switch ic with DG3537 if you are looking for variants. In this multiplexer, the internal resistance is 4Ohm. To find out what the 8 pins do, please refer to the datasheets. A voltage higher than 5.5V should not normally be supplied to the switches. Analogue multiplexer with a Single supply type that is cost-effective. In order for the electronic part to function properly, the lowest voltage should be 1.8V. An operating current of 1nA would be sufficient for this switch device. Using only a single voltage supply, this analog switch requires 1.8V~5.5V voltage. When the digital multiplexer is charged above 1μA, damage can occur. A temperature above 85°C is not suitable for operation of the analogue multiplexer. Suppliers offer a package with 8-MicroFoot? (1.5x1.5).

DG3537DB-T5-E1 Features


Switch Circuit: SPST - NO/NC
1nA Supply Current
-3db Bandwidth: 360MHz

DG3537DB-T5-E1 Applications


There are a lot of Vishay Siliconix DG3537DB-T5-E1 Analog Switches & Multiplexers ICs applications.

  • Data Acquisition Systems
  • DVD-R
  • PCMCIA cards
  • Intelligent PBX
  • Cable PC
  • PBX interfaces
  • Imaging
  • Residential Gateways, Home Gateway/Router
  • Ultrasound
  • Battery-powered systems

Write a review

Note: HTML is not translated!
    Bad           Good