Parameters |
Supply Type |
Dual, Single |
Turn-Off Delay Time |
130 ns |
Max Dual Supply Voltage |
22V |
On-State Resistance (Max) |
50Ohm |
Min Dual Supply Voltage |
7V |
Dual Supply Voltage |
15V |
Multiplexer/Demultiplexer Circuit |
2:1 |
Current - Leakage (IS(off)) (Max) |
5nA |
Channel Capacitance (CS(off), CD(off)) |
14pF 14pF |
Switch Circuit |
SPDT |
Switch Time (Ton, Toff) (Max) |
150ns, 130ns (Typ) |
Charge Injection |
10pC |
Crosstalk |
-74dB @ 500kHz |
Drain to Source Resistance |
50Ohm |
Voltage - Supply, Dual (V±) |
±15V |
RoHS Status |
Non-RoHS Compliant |
Factory Lead Time |
1 Week |
Mounting Type |
Through Hole |
Package / Case |
16-DIP (0.300, 7.62mm) |
Number of Pins |
16 |
Operating Temperature |
-40°C~85°C TA |
Packaging |
Tube |
Published |
2005 |
Pbfree Code |
no |
Part Status |
Obsolete |
Moisture Sensitivity Level (MSL) |
1 (Unlimited) |
Resistance |
50Ohm |
Max Power Dissipation |
470mW |
Reach Compliance Code |
unknown |
Pin Count |
16 |
Operating Supply Voltage |
15V |
Number of Circuits |
2 |
Max Supply Voltage |
36V |
Min Supply Voltage |
13V |
Nominal Supply Current |
230μA |
Max Supply Current |
1mA |
Turn On Delay Time |
150 ns |
DG390BDJ Overview
Presented in 16-DIP (0.300, 7.62mm), this electrical component is convenient for overseas shipping. The advanced packaging method Tube provides high reliability. A switch device like this is mounted in Through Hole. Multiplexer and demultiplexer circuits have a number 2:1. Extended operating temperature around -40°C~85°C TA. This electrical component is included in the 16 series of products. The analog switch ics are built using SPDT switching circuits. Circuits number 2 make up this analogue multiplexer. As far as internal resistance is concerned, it has 50Ohm. For details about the functions of 16 pins, please refer to the datasheets. In normalcircumstances, users should not exceed 36V volts for the multiplexer. Analog switch ics with Dual, Single supply type are cost-effective. There should be 13V voltage fed to the electrical part below 13V. A voltage higher than 1mA may cause damage to the switch multiplexer. There's no problem with dual supply voltage for this switch device. However, it shouldn't exceed 22V. For dual power supplies, a voltage of at least 7V should be attached. Operating voltages range from 15V. Resistivity from Drain to Source is 50Ohm for this electronic part.
DG390BDJ Features
Switch Circuit: SPDT
Drain-to-Source resistance: 50Ohm
DG390BDJ Applications
There are a lot of Vishay Siliconix DG390BDJ Analog Switches & Multiplexers ICs applications.
- MP3 players
- ISDN NT1/TA
- PBXs
- Ultrasound
- Audio and video switching
- Video signal routing
- Medical systems
- Cable PC
- Routers
- Communication systems