DG403DY-E3

150ns, 100ns SPST - NO/NC 45Ohm Analog Switches BREAK-BEFORE-MAKE DG403 16 Pins 500pA 15V 16-SOIC (0.154, 3.90mm Width)

Manufacturer: Vishay Siliconix
Nocochips NO: 880-DG403DY-E3
Package: 16-SOIC (0.154, 3.90mm Width)
Datasheet: PDF
Stock: 699
Description: 150ns, 100ns SPST - NO/NC 45Ohm Analog Switches BREAK-BEFORE-MAKE DG403 16 Pins 500pA 15V 16-SOIC (0.154, 3.90mm Width)(Kg)

Details

Tags

Parameters
Factory Lead Time	1 Week
Contact Plating	Tin
Mount	Surface Mount
Mounting Type	Surface Mount
Package / Case	16-SOIC (0.154, 3.90mm Width)
Number of Pins	16
Weight	665.986997mg
Operating Temperature	-40°C~85°C TA
Packaging	Tube
Published	2006
JESD-609 Code	e3
Pbfree Code	yes
Part Status	Active
Moisture Sensitivity Level (MSL)	1 (Unlimited)
Number of Terminations	16
Resistance	45Ohm
Subcategory	Multiplexer or Switches
Max Power Dissipation	600mW
Technology	CMOS
Terminal Form	GULL WING
Peak Reflow Temperature (Cel)	260
Number of Functions	2
Supply Voltage	15V
Time@Peak Reflow Temperature-Max (s)	30
Base Part Number	DG403
Pin Count	16
Number of Outputs	4
Output Type	Digital
Operating Supply Voltage	15V
Polarity	Non-Inverting
Number of Channels	1
Number of Circuits	2
Max Supply Voltage	36V
Min Supply Voltage	13V
Operating Supply Current	5μA
Nominal Supply Current	10nA
Power Dissipation	600mW
Max Supply Current	1μA
Throw Configuration	SPDT
Turn On Delay Time	150 ns
Voltage - Supply, Single/Dual (±)	5V~34V ±5V~17V
Supply Type	Dual, Single
Neg Supply Voltage-Nom (Vsup)	-15V
Turn-Off Delay Time	100 ns
Max Dual Supply Voltage	22V
On-State Resistance (Max)	45Ohm
Min Dual Supply Voltage	7V
High Level Output Current	100mA
Dual Supply Voltage	15V
Multiplexer/Demultiplexer Circuit	1:1
Off-state Isolation-Nom	72 dB
Current - Leakage (IS(off)) (Max)	500pA
Channel Capacitance (CS(off), CD(off))	12pF 12pF
On-state Resistance Match-Nom	3Ohm
Switch Circuit	SPST - NO/NC
Switch Time (Ton, Toff) (Max)	150ns, 100ns
Charge Injection	60pC
Channel-to-Channel Matching (ΔRon)	3 Ω
Crosstalk	-90dB @ 1MHz
Switching	BREAK-BEFORE-MAKE
Height	1.55mm
Length	10mm
Width	4mm
Radiation Hardening	No
RoHS Status	ROHS3 Compliant
Lead Free	Lead Free

DG403DY-E3 Overview

The electronic part can be shipped overseas conveniently because it is packaged in 16-SOIC (0.154, 3.90mm Width). High reliability is achieved by using advanced packaging method Tube. Mounted in Surface Mount is this multiplexer. 1:1 is the ratio of multiplexer to demultiplexer circuits. Operating temperature extended to -40°C~85°C TA. Totally, there are 16 terminations. High-quality output is provided by the electronic component's 1 channels. An 15V voltage supply should allow the electrical part to be turned on and run. As part of its design, the 16 series is equipped with this electronic component. SPST - NO/NC switching circuits are used in these analog switch ics. It consists of 2 circuits. Try searching for DG403 variants of the analog switch ic. There is 45Ohm internal resistance in this digital multiplexer. The functions of 16 pins can be found in the datasheets. Theswitch device is a typical Multiplexer or Switches. In a normalsituation, users should not supply the switches with voltage higher than 36V. Dual, Single supply type digital switch with a low cost. The lowest voltage the electronic part should receive is 13V. It would be sufficient to run this analogue multiplexer with 5μA current. A digital multiplexer may suffer damage if voltage is applied above 1μA. For this multiplexer, dual supply voltage is feasible, but it should not exceed 22V. If you are using dual power supplies, you should attach at least 7V. This electrical part is compatible with 15V operating voltages. 4 outputs are included in the analogue multiplexer.