DG406DYZ-T
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Contact Plating | Tin |
| Mount | Surface Mount |
| Package / Case | SOIC |
| Number of Pins | 28 |
| Published | 2000 |
| JESD-609 Code | e3 |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 3 |
| Number of Terminations | 28 |
| ECCN Code | EAR99 |
| Resistance | 100Ohm |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Technology | CMOS |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Supply Voltage | 15V |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Pin Count | 28 |
| Operating Supply Voltage | 28V |
| Temperature Grade | INDUSTRIAL |
| Number of Channels | 1 |
| Max Supply Voltage | 40V |
| Min Supply Voltage | 5V |
| Operating Supply Current | 80μA |
| Propagation Delay | 300 ns |
| Turn On Delay Time | 600 ns |
| Logic Function | Multiplexer |
| Supply Type | Dual, Single |
| Supply Current-Max (Isup) | 0.2mA |
| Neg Supply Voltage-Nom (Vsup) | -15V |
| Turn-Off Delay Time | 300 ns |
| Max Dual Supply Voltage | 20V |
| Min Dual Supply Voltage | 5V |
| High Level Output Current | 30mA |
| Off-state Isolation-Nom | 69 dB |
| On-state Resistance Match-Nom | 5Ohm |
| Switching | BREAK-BEFORE-MAKE |
| Switch-on Time-Max | 200ns |
| Height Seated (Max) | 2.65mm |
| Width | 7.5mm |
| Radiation Hardening | No |
| RoHS Status | RoHS Compliant |
| Lead Free | Lead Free |
DG406DYZ-T Overview
The electronic part can be shipped overseas conveniently because it is packaged in SOIC. In total, there have been 28 terminations. By its 1 channels, the electronic component provides high-quality output. In the case of a voltage supply of 15V volts, the electrical part can be powered up and run. A key feature of the 28 series is the inclusion of this electronic part as part of its design. As far as internal resistance is concerned, it has 100Ohm. The functions of 28 pins can be found in the datasheets. It is generally not recommended to supply a voltage higher than 40V to the switch device in normal circumstances. The analog switch ic is of the Dual, Single supply type and is cost-effective. It is recommended to use 5V as the lowest voltage for the electrical part. It would be sufficient to run this analogue multiplexer with 80μA current. Despite this switch device's dual supply capability, its voltage should not exceed 20V. For dual power supplies, a voltage of at least 5V should be attached. 28V operating voltages are supported by the electronic component. Temperatures above 85°C degrees Celsius should not be operated by the multiplexer.
DG406DYZ-T Features
1 Channels
80μA Supply Current
DG406DYZ-T Applications
There are a lot of Intersil (Renesas Electronics America) DG406DYZ-T Analog Switches & Multiplexers ICs applications.
- RGB switches
- Avionics
- Mechanical reed relay replacement
- Automatic test equipment
- Precision test equipment
- Sample-and-hold systems
- High reliability control systems
- Multi-Line E1 Interface Cards
- DVD-R
- Imaging
