DG409DJ
| Parameters | |
|---|---|
| Mount | Through Hole |
| Package / Case | DIP |
| Number of Pins | 16 |
| Packaging | Bulk |
| Published | 1999 |
| JESD-609 Code | e0 |
| Part Status | Discontinued |
| Number of Terminations | 16 |
| Resistance | 100Ohm |
| Terminal Finish | Tin/Lead (Sn/Pb) |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Technology | CMOS |
| Peak Reflow Temperature (Cel) | NOT SPECIFIED |
| Number of Functions | 1 |
| Supply Voltage | 15V |
| Reach Compliance Code | not_compliant |
| Time@Peak Reflow Temperature-Max (s) | NOT SPECIFIED |
| Pin Count | 16 |
| Qualification Status | Not Qualified |
| Supply Voltage-Max (Vsup) | 20V |
| Power Supplies | 12/+-15V |
| Temperature Grade | INDUSTRIAL |
| Supply Voltage-Min (Vsup) | 5V |
| Number of Channels | 4 |
| Operating Supply Current | 200μA |
| Throw Configuration | 4PST |
| Logic Function | Multiplexer |
| Supply Type | Dual, Single |
| Supply Current-Max (Isup) | 2mA |
| Neg Supply Voltage-Nom (Vsup) | -15V |
| Off-state Isolation-Nom | 75 dB |
| Neg Supply Voltage-Max (Vsup) | -20V |
| On-state Resistance Match-Nom | 15Ohm |
| Switching | BREAK-BEFORE-MAKE |
| Switch-on Time-Max | 150ns |
| Switch-off Time-Max | 150ns |
| Drain to Source Resistance | 40Ohm |
| Signal Current-Max | 0.02A |
| Neg Supply Voltage-Min (Vsup) | -5V |
| Height Seated (Max) | 5.33mm |
| Length | 19.17mm |
| Width | 7.62mm |
| RoHS Status | Non-RoHS Compliant |
| Lead Free | Contains Lead |
DG409DJ Overview
Packed in DIP, the electronic component is convenient for shipping overseas. In order to provide high reliability, an advanced packaging method Bulk is used. Total terminations are 16. High-quality output is provided by the electronic component's 4 channels. When a voltage supply of 15V is used, the electronic component should be turned on and run. An electrical component of this type can be found in the 16 series. A 100Ohm internal resistance characterizes this multiplexer. For details about the functions of 16 pins, please refer to the datasheets. Analog switch ics with Dual, Single supply type are cost-effective. 200μA current would be enough for this multiplexer to operate. Temperatures over 85°C should not be allowed for the multiplexer to operate. A Drain to Source resistance of 40Ohm is shown for this electronic part. It requires a minimum voltage of 5V to supply the switch device.
DG409DJ Features
4 Channels
200μA Supply Current
Drain-to-Source resistance: 40Ohm
DG409DJ Applications
There are a lot of Intersil (Renesas Electronics America) DG409DJ Analog Switches & Multiplexers ICs applications.
- Avionics
- Ultrasound
- Multiplexers
- T1/E1 Terminals
- Medical
- SDH/SONET multiplexers
- Channel Banks
- Remote Powered Equipment
- Cell phones
- 65 V DACs
