DG411CUE+

175ns, 145ns SPST - NC 45Ohm Analog Switches BREAK-BEFORE-MAKE DG411 16 Pins 250pA 15V 16-TSSOP (0.173, 4.40mm Width)

Manufacturer: Maxim Integrated
Nocochips NO: 503-DG411CUE+
Package: 16-TSSOP (0.173, 4.40mm Width)
Datasheet: PDF
Stock: 663
Description: 175ns, 145ns SPST - NC 45Ohm Analog Switches BREAK-BEFORE-MAKE DG411 16 Pins 250pA 15V 16-TSSOP (0.173, 4.40mm Width)(Kg)

Details

Tags

Parameters
Switch-on Time-Max	175ns
Normal Position	NC
Height Seated (Max)	1.1mm
Length	5mm
Radiation Hardening	No
RoHS Status	ROHS3 Compliant
Lead Free	Lead Free
Factory Lead Time	1 Week
Mount	Surface Mount
Mounting Type	Surface Mount
Package / Case	16-TSSOP (0.173, 4.40mm Width)
Number of Pins	16
Operating Temperature	0°C~70°C TA
Packaging	Tube
Published	2010
JESD-609 Code	e3
Pbfree Code	yes
Part Status	Active
Moisture Sensitivity Level (MSL)	1 (Unlimited)
Number of Terminations	16
ECCN Code	EAR99
Resistance	80Ohm
Terminal Finish	Matte Tin (Sn)
Subcategory	Multiplexer or Switches
Max Power Dissipation	457mW
Technology	CMOS
Terminal Form	GULL WING
Peak Reflow Temperature (Cel)	260
Number of Functions	4
Supply Voltage	15V
Terminal Pitch	0.65mm
Time@Peak Reflow Temperature-Max (s)	30
Base Part Number	DG411
Output	SEPARATE OUTPUT
Pin Count	16
Power Supplies	512/+-15V
Number of Channels	1
Number of Circuits	4
Max Supply Voltage	30V
Min Supply Voltage	10V
Operating Supply Current	100pA
Nominal Supply Current	100pA
Max Supply Current	1μA
Throw Configuration	SPST
Turn On Delay Time	250 ns
Voltage - Supply, Single/Dual (±)	10V~30V ±4.5V~20V
Supply Type	Dual, Single
Neg Supply Voltage-Nom (Vsup)	-15V
Turn-Off Delay Time	125 ns
Max Dual Supply Voltage	20V
On-State Resistance (Max)	45Ohm
Min Dual Supply Voltage	4.5V
Multiplexer/Demultiplexer Circuit	1:1
Off-state Isolation-Nom	68 dB
Current - Leakage (IS(off)) (Max)	250pA
Channel Capacitance (CS(off), CD(off))	9pF 9pF
On-state Resistance Match-Nom	3Ohm
Switch Circuit	SPST - NC
Switch Time (Ton, Toff) (Max)	175ns, 145ns
Charge Injection	5pC
Channel-to-Channel Matching (ΔRon)	3 Ω (Max)
Crosstalk	-85dB @ 1MHz
Switching	BREAK-BEFORE-MAKE

DG411CUE+ Overview

The electronic component is convenient to ship overseas because it is packed in a 16-TSSOP (0.173, 4.40mm Width). High reliability is achieved by using advanced packaging method Tube. In Surface Mount, this analog switch is mounted. The ratio between the number of multiplexer and demultiplexer circuits is 1:1. The operating temperature is extended to around 0°C~70°C TA. In total, there are 16 terminations. By its 1 channels, the electronic component provides high-quality output. It is safe to turn on and run the electronic component with a 15V voltage supply. 16 pins are injected to the electronic part body. Circuits based on SPST - NC switching are used to construct these analog switch ics. This multiplexer is composed of 4 circuits. Look for analog switch ic variants by searching with DG411. This digital multiplexer has 80Ohm internal resistance. The functions of 16 pins can be found in the datasheets. It is a typical Multiplexer or Switches analog multiplexer. Users shouldn't supply more than 30V voltage to the switch device. A cost-effective Dual, Single supply type analogue multiplexer. The lowest voltage the electronic part should receive is 10V. It would be sufficient to run this analogue multiplexer with 100pA current. If you put voltage higher than 1μA on the digital multiplexer, damage may occur. For this multiplexer, dual supply voltage is feasible, but it should not exceed 20V. In the case of dual power supplies, you should connect at least 4.5V. It is possible to use SEPARATE OUTPUT outputs on this digital multiplexer.