DG412DJZ
| Parameters | |
|---|---|
| Dual Supply Voltage | 9V |
| Off-state Isolation-Nom | 68 dB |
| Switching | BREAK-BEFORE-MAKE |
| Drain to Source Resistance | 35Ohm |
| Normal Position | NC |
| Height | 4.95mm |
| Length | 19.68mm |
| Width | 7.11mm |
| Radiation Hardening | No |
| REACH SVHC | No SVHC |
| RoHS Status | RoHS Compliant |
| Lead Free | Lead Free |
| Factory Lead Time | 1 Week |
| Mount | Surface Mount, Through Hole |
| Package / Case | PDIP |
| Number of Pins | 16 |
| Published | 1999 |
| JESD-609 Code | e3 |
| Part Status | Active |
| Number of Terminations | 16 |
| ECCN Code | EAR99 |
| Resistance | 35Ohm |
| Terminal Finish | Matte Tin (Sn) - annealed |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Subcategory | Multiplexer or Switches |
| Technology | CMOS |
| Number of Functions | 4 |
| Supply Voltage | 15V |
| Output | SEPARATE OUTPUT |
| Temperature Grade | INDUSTRIAL |
| Number of Channels | 4 |
| Max Supply Voltage | 40V |
| Min Supply Voltage | 5V |
| Operating Supply Current | 100pA |
| Nominal Supply Current | 100pA |
| Max Supply Current | 5μA |
| Throw Configuration | SPST |
| Turn On Delay Time | 175 ns |
| Supply Type | Dual, Single |
| Neg Supply Voltage-Nom (Vsup) | -15V |
| Turn-Off Delay Time | 145 ns |
| Max Dual Supply Voltage | 20V |
| Min Dual Supply Voltage | 5V |
DG412DJZ Overview
Due to its PDIP packaging, the electronic part is convenient for international shipping. 16 terminations have been made so far. The electronic part provides high-quality output because it has 4 channels. When the electronic component is given a voltage of 15V, it should be turned on and run. This digital multiplexer has 35Ohm internal resistance. For functions related to 16 pins, please refer to the datasheets. This switch device is a typical Multiplexer or Switches. It is generally not recommended to supply a voltage higher than 40V to the switch device in normal circumstances. The digital multiplexer has a low cost Dual, Single supply. There should be 5V voltage fed to the electrical part below 5V. This digital switch can be operated with a current of 100pA. A digital multiplexer may suffer damage if voltage is applied above 5μA. If put voltage greater than 20V on the multiplexer, damage may be caused to the device. When using dual power supplies, you should attach at least 5V. As far as the outputs go, this switch multiplexer utilizes SEPARATE OUTPUT of them. It is not recommended to operate the switches in an environment with a temperature higher than 85°C. A Drain to Source resistance of 35Ohm is shown for this electronic part.
DG412DJZ Features
4 Channels
100pA Supply Current
Drain-to-Source resistance: 35Ohm
DG412DJZ Applications
There are a lot of Intersil (Renesas Electronics America) DG412DJZ Analog Switches & Multiplexers ICs applications.
- Battery-powered systems
- Intelligent PBX
- MP3 players
- Voice over IP/DSL – Integrated Access Devices, Smart
- Digital access cross connects
- Ultrasound
- E1 Multiplexer
- SONET/SDH ADM
- Frame Relay Equipment
- New designs requiring multiplexer functions
