DG412DY
| Parameters | |
|---|---|
| Part Status | Discontinued |
| Moisture Sensitivity Level (MSL) | 1 |
| Number of Terminations | 16 |
| Resistance | 80Ohm |
| Terminal Finish | Tin/Lead (Sn/Pb) |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Subcategory | Multiplexer or Switches |
| Technology | CMOS |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 240 |
| Number of Functions | 4 |
| Supply Voltage | 15V |
| Terminal Pitch | 1.27mm |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Output | SEPARATE OUTPUT |
| Pin Count | 16 |
| Qualification Status | Not Qualified |
| Supply Voltage-Max (Vsup) | 20V |
| Power Supplies | 512/+-15V |
| Temperature Grade | INDUSTRIAL |
| Supply Voltage-Min (Vsup) | 5V |
| Number of Channels | 1 |
| Operating Supply Current | 100pA |
| Number of Bits | 4 |
| Throw Configuration | SPST |
| Supply Type | Dual, Single |
| Neg Supply Voltage-Nom (Vsup) | -15V |
| Off-state Isolation-Nom | 68 dB |
| Neg Supply Voltage-Max (Vsup) | -20V |
| Switching | BREAK-BEFORE-MAKE |
| Switch-on Time-Max | 175ns |
| Drain to Source Resistance | 35Ohm |
| Normal Position | NO |
| Neg Supply Voltage-Min (Vsup) | -5V |
| Height Seated (Max) | 1.75mm |
| Length | 9.9mm |
| Width | 3.9mm |
| RoHS Status | RoHS Compliant |
| Lead Free | Contains Lead |
| Mount | Surface Mount |
| Package / Case | SOIC |
| Number of Pins | 16 |
| Packaging | Bulk |
| Published | 1999 |
| JESD-609 Code | e0 |
DG412DY Overview
The electronic part can be shipped overseas conveniently because it is packaged in SOIC. High reliability is provided by advanced packaging method Bulk. There are 16 terminations totally. A 1 channel electronic part produces high-quality output. If the voltage supply is 15V volts, the electrical component should be turned on and run. Into the electrical component body are injected 16 pins. There is 80Ohm internal resistance in this digital multiplexer. The functions of 16 pins can be found in the datasheets. In this analog multiplexer, the value is Multiplexer or Switches. Analog switch ics with Dual, Single supply type are cost-effective. The analogue multiplexer could operate on 100pA current. As far as the outputs go, this switch multiplexer utilizes SEPARATE OUTPUT of them. It is not recommended to operate the switches in an environment with a temperature higher than 85°C. Drain to Source resistance is 35Ohm. 4-bit operation is possible. Analog switch ics need a voltage of 5V to be powered.
DG412DY Features
1 Channels
100pA Supply Current
Drain-to-Source resistance: 35Ohm
4-Bit
DG412DY Applications
There are a lot of Intersil (Renesas Electronics America) DG412DY Analog Switches & Multiplexers ICs applications.
- ISDN NT1/TA
- Signal routing between systems
- Avionics and Military Systems
- Fiber In The Loop (FITL)
- SDH/SONET multiplexers
- Communications systems
- Industrial control systems
- Digital Cross-Connects
- Multi-Line E1 Interface Cards
- PBX interfaces
