DG413CJ+
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Package / Case | PDIP |
| Surface Mount | NO |
| Number of Pins | 16 |
| Packaging | Tube |
| Published | 2010 |
| JESD-609 Code | e3 |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 16 |
| ECCN Code | EAR99 |
| Terminal Finish | Matte Tin (Sn) |
| HTS Code | 8542.39.00.01 |
| Subcategory | Multiplexer or Switches |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | THROUGH-HOLE |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 4 |
| Supply Voltage | 15V |
| Terminal Pitch | 2.54mm |
| Output | SEPARATE OUTPUT |
| Pin Count | 16 |
| Operating Temperature (Max) | 70°C |
| Power Supplies | 512/+-15V |
| Temperature Grade | COMMERCIAL |
| Number of Channels | 1 |
| Max Supply Voltage | 30V |
| Min Supply Voltage | 10V |
| Analog IC - Other Type | SPST |
| Neg Supply Voltage-Nom (Vsup) | -15V |
| Max Dual Supply Voltage | 20V |
| On-State Resistance (Max) | 45Ohm |
| Min Dual Supply Voltage | 4.5V |
| Off-state Isolation-Nom | 68 dB |
| On-state Resistance Match-Nom | 3Ohm |
| Switching | BREAK-BEFORE-MAKE |
| Switch-on Time-Max | 175ns |
| Switch-off Time-Max | 145ns |
| Height Seated (Max) | 4.572mm |
| Length | 19.175mm |
| Width | 7.62mm |
| Radiation Hardening | No |
| RoHS Status | ROHS3 Compliant |
DG413CJ+ Overview
Due to its PDIP packaging, the electronic part is convenient for international shipping. In order to provide high reliability, an advanced packaging method Tube is used. In total, there are 16 terminations. High-quality output is provided by the electronic component's 1 channels. In the case of a voltage supply of 15V volts, the electrical part can be powered up and run. It is part of the design of the 16 series that this electronic component is included. You can find the functions of the 16 pins in the datasheets. Multiplexer or Switches is a typical switch device. Multiplexers should not be powered above 30V in normal situations. 10V is the lowest voltage that should be fed to the electronic electronic part. For this multiplexer, dual supply voltage is feasible, but it should not exceed 20V. When using dual power supplies, you should attach at least 4.5V. There is an analog IC SPST integrated with this board. As far as the outputs go, this switch multiplexer utilizes SEPARATE OUTPUT of them. A temperature higher than 70°C may result in a malfunction of the switch multiplexer.
DG413CJ+ Features
1 Channels
DG413CJ+ Applications
There are a lot of Maxim Integrated DG413CJ+ Analog Switches & Multiplexers ICs applications.
- Channel Banks
- Digital access cross connects
- High speed data transmission line cards
- Private Branch Exchange (PBX)
- Data switching
- Audio and video signal routing
- Data Acquisition Systems
- Remote wireless modules
- Avionics
- Optical Applications
